Summit SWCD40 Gebrauchsanleitung
- 6 -
Technical Data
Model Number
SWCD40
Type
2-drawer wine cellar
Capacity
40 bottles (5.3 ft
3
)
Electrical Rating
110V AC, 60 Hz
Rated Current
1.5A
Input Power
140W
Power Consumption
438 kWh/yr
Temperature Control Range
Upper Zone: 40-50°F
Lower Zone: 50-64°F
Net Weight
136.4 lbs
Unit Size (W×D×H)
23.4" x 22.4" x 33.1"
Installation Instructions
Your SWCD40 wine cellar may be installed either built-in or free-standing, but it is important that
the front of the unit be kept clear of obstructions, especially the vents at the bottom. If it is built in,
you should provide the following clearances to ensure the best operation and proper ventilation:
3/16” on both sides, 2” at the rear and 1/16” at the top. Don’t block airflow under the appliance.
Before using your wine cooler:
• Remove the exterior and interior packing.
• Never lift the unit by the drawer handles.
• Never install or operate the unit behind closed cabinet doors.
• Before connecting the appliance to the power source, let it stand upright for approximately 2
• Remove the exterior and interior packing.
• Never lift the unit by the drawer handles.
• Never install or operate the unit behind closed cabinet doors.
• Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a floor that is strong enough to support the appliance when it is fully
• Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded.
• To level your appliance, adjust the front legs at the bottom of the appliance.
• Install the two stainless steel handles according to the following illustration:
• Install the two stainless steel handles according to the following illustration: