Whirlpool WFE540H0EB Benutzung Und Pflege

The oven light is a standard 40-watt appliance bulb. Before 
replacing, make sure the oven and cooktop are cool and the 
control knobs are in the off position.

1. Unplug range or disconnect power.

2. Turn the glass bulb cover in the back of the oven 

counterclockwise to remove.

3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer 
to the warranty page in this manual and scan the code there with your mobile device, or visit http://www.whirlpool.com/product_help.

Contact us by mail with any questions or concerns at the address below:

In the U.S.A.:

Whirlpool Brand Home Appliances



Customer eXperience Center



553 Benson Road



Benton Harbor, MI 49022-2692

Please include a daytime phone number in your correspondence.

Power supply cord is unplugged.

Plug into a grounded outlet.

ENERGY SAVE is active, and the 
display is blank.

Press any key on the control to display the Time of Day. See the 
“Electronic Oven Controls” section for more information.

Household fuse is blown, or a circuit 
breaker is tripped.

Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

The control displays an F9 or F9 E0 
error code.

The electrical outlet in the home may be miswired. Contact a 
qualified electrician to verify the electrical supply.

The control knob is not set correctly.

Push in knob before turning to a setting.

On ceramic glass models, the oven 
control lockout is set.

See the control lock keypad feature in the “Feature Guide.”

Cookware is not the proper size.

Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than 

¹⁄₂" (1.3 cm) outside the cooking area.

Control knob set to incorrect heat 
level.

See “Cooktop Use” section.

Range is not level.

Level the range. See the Installation Instructions.

Element cycling due to a temperature 
limiter.

This is normal operation. The element may cycle on and off to 
keep the cooktop from overheating.

Delay start is set.

See “Cook Time” section.

Control lock is on.

Press and hold START for 3 seconds to unlock.

Control is in Demo Mode.

Press and hold START TIME for 10 seconds to exit Demo 
Mode. Demo Mode is used for display models in a showroom.

Electronic oven control set incorrectly.

See “Electronic Oven Controls” section.

Oven temperature needs adjustment.

See “Oven Temperature Control” in the “Electronic Oven 
Controls” section.

Power to range is turned on or 
restored.

See “Control Display” in the “Electronic Oven Controls” 
section. If the indicator lights keep flashing, call for service. See 
cover for contact information.

Power failure (display shows flashing 
time).

Clear the display. On some models, reset the clock, if needed. 
See “Clock” keypad feature in the “Feature Guide” section.

Error code (display shows letter 
followed by number).

Depending on your model, press CANCEL to clear the display. 
See “Control Display” in the “Electronic Oven Controls” 
section. If it reappears, call for service. See cover for contact 
information.

Start needs to be pressed so a cycle 
can begin (display shows “PUSH” or 
“PSH”).

See the “Start” keypad feature in the “Feature Guide” section.