Viking RVDR33015BBK Installationsanweisungen
25
24
Performance Checklist
A qualified installer should carry out the
following checks:
following checks:
□ Check top burner
ignition. See
drawing for proper
flame height on HI.
The low flame should
light at every port.
drawing for proper
flame height on HI.
The low flame should
light at every port.
□ Check oven bake function—bake element
on full power, center and outside broil
elements at partial power.
elements at partial power.
□ Convection bake function—bake and broil
elements the same with the convection fan
on.
on.
□ Check TruConvec™ function—TruConvec
element (behind convection fan cover) on
and convection fan on.
and convection fan on.
□ Check HI broil function–both broil
elements at full power.
□ Check LOW broil function—inner broil
element only.
□ Check convection broil function—both
broil elements at full power with convection
fan on.
fan on.
□ Check self-clean function—door will lock in
approximately 30 seconds, the center and
outside broil elements will turn on and the
bake element will turn on at partial power.
Check broil elements through window to
make sure they are on, then abort
self-clean cycle to unlock door.
outside broil elements will turn on and the
bake element will turn on at partial power.
Check broil elements through window to
make sure they are on, then abort
self-clean cycle to unlock door.
Final Preparation
• All stainless steel body parts should be
wiped with hot, soapy water and with a
liquid cleaner designed for this material.
If buildup occurs, DO NOT use steel wool,
abrasive cloths, cleansers, or powders!
If it is necessary to scrape stainless steel
liquid cleaner designed for this material.
If buildup occurs, DO NOT use steel wool,
abrasive cloths, cleansers, or powders!
If it is necessary to scrape stainless steel
to remove encrusted materials, soak with hot,
wet cloths to loosen the material, then use a
wool or nylon scraper. DO NOT use a metal
knife, spatula, or any other material tool to
scrape stainless steel! Scratches are almost
impossible to remove.
wet cloths to loosen the material, then use a
wool or nylon scraper. DO NOT use a metal
knife, spatula, or any other material tool to
scrape stainless steel! Scratches are almost
impossible to remove.
NOTICE
When conducting performance test,
DO NOT run self-clean cycle for more
than 10 minutes with oven racks inside
oven. This could cause them to discolor
due to the high temperature required
for self-cleaning.
DO NOT run self-clean cycle for more
than 10 minutes with oven racks inside
oven. This could cause them to discolor
due to the high temperature required
for self-cleaning.
1-1/2”
(3.8 cm)
(3.8 cm)
3/8”
(0.95 cm)
Door Replacement and Adjustment
1
1
2
2
3
2
Reattach door to range.
Open door completely. Reattach
hinge trim on both sides.
3
4
Remove pins from holes in hinges.
Close door.
5
If the door needs to be adjusted, loosen hinge trim screws
located in Step 2. Adjust the screws located between the
door and kickplate using a 5/32” hex head Allen wrench.
door and kickplate using a 5/32” hex head Allen wrench.
After adjustment, tighten hinge trim screws.