Dacor DYRP48DCNG Benutzung Und Pflege

50

Removing the Range from the Wall for 

Cleaning

1.  Turn the gas supply valve to the off position.
2.  Turn off power to the range at the circuit breaker 

panel or fuse box.

3.  Pull the range out from the wall.

Replacing the Range after Cleaning

1.  Push the range back into the operating position. 

Make sure the anti-tip bracket is engaged (see inside 

cover). 

2.  Turn on power to the range at the circuit breaker 

panel or fuse box.

3.  Turn the gas supply valve to the on position.

Stainless Steel Surfaces

Always wipe stainless steel (silver colored) surfaces with the 

grain. To prevent scratching, do not use abrasive cleaners or 

scrubbers on stainless steel surfaces.

Using a soft cloth, clean metal surfaces with a mild solu-

tion of detergent and warm water. Rinse and dry with a 

soft, lint-free cloth.

Cleaning Chrome Surfaces

To prevent scratching, do not use abrasive cleaners or scrubbers 

on metal surfaces.

Using a soft cloth, clean metal surfaces with a mild solu-

tion of detergent and warm water. Rinse and dry with a 

soft, lint-free cloth.

Glass (Interior and Exterior)

Use a mild glass cleaner to remove finger prints on glass 

surfaces. You can also clean glass surfaces with Dacor 

Cooktop Cleaning Creme. Use it according to the direc-

tions on the package.
You may scrub the oven light lens with the rough side of a 

sponge and warm, soapy water. Be careful not to scratch 

the lens.

Control Panel

Do not use abrasive cleaners or scrubbers on the control panel. 

They will permanently damage the finish.

To avoid turning the oven on while 

cleaning the control panel, activate the 

lock-out feature. Touch and hold your 

finger on the CANCEL RIGHT key for 

five seconds. The keys will be disabled and Locked will 

appear on the display.
Clean the control panel with the soft side of a sponge 

dampened with a mild solution of detergent and warm 

water. Dry the control panel completely with a soft, lint-

free cloth.
To re-activate the control panel, touch and hold your 

finger on the CANCEL RIGHT key for five seconds.

Knobs and Trim Rings

•  Do not soak the knobs in water or put them in the 

dishwasher.

•  Do not remove the trim rings from the range. Clean only the 

outside edges of the trim rings. If you get moisture inside the 

trim rings, damage to the knob lights or other parts of the 

range can occur.

•  Installing the range knobs in the wrong position may result 

in damage to the griddle included with the range. The knobs 

for the center burners are marked with the maximum griddle 

settings.

•  To prevent damage, do not use abrasive or corrosive 

cleaners or applicators.

•  Wash the knobs regularly with a solution of warm 

soapy water. Dacor recommends hand dishwashing 

liquid.

•  Turn the knobs to the off position to remove them for 

cleaning or replacement.

•  Grasp each knob and pull straight back, off of the 

valve shaft.

•  Clean the outside edges of the trim rings while the 

knobs are removed. Wipe them with a soft damp rag.

•  To replace the knobs, align the “D” shaped opening on 

the back of the knob with the end of the valve shaft. 

Carefully push the 

knob on until it stops. 

Make sure you put the 

two knobs with the 

words “MAX GRIDDLE” 

on the center burner 

valve stems (closest to 

the control panel).

Care and Cleaning