BlueStar BSPRT6010B Installationsanweisungen
8
BACKGUARD
All rangetops require a backguard. Most models have the option of using: grate height trim; island trim;
6” inch standard; 17” inch hi-back; 24” inch high shelf. Heritage Classic models require a 24” inch high
shelf for all installations.
shelf for all installations.
If you are using an island trim or grate height trim, a six inch clearance between the back of the rangetop
and a combustible surface is required. If an island trim is to be used without this six inch clearance, the
back wall must be constructed using non-combustible and heat resistant materials that extend below the
top surface of the range a minimum of six inches.
back wall must be constructed using non-combustible and heat resistant materials that extend below the
top surface of the range a minimum of six inches.
All backguards follow the same basic installation. Remove rear grates, slide backguard over rear of unit,
align holes, use hardware supplied to fasten backguard to unit. A minimum of six sheet metal screws
(more depending on width) are to be installed, three on each end and more along the bottom edge.
(more depending on width) are to be installed, three on each end and more along the bottom edge.
Remove the two rear ring grate/top grates from the cooktop surface. Sheet metal screws must be installed
- down - into the cooktop support. Screws are installed on each end ring grate/top grate position.
Replace the removed grates.
Replace the removed grates.