Danby DR240WGLP Benutzeranleitung

Seal any openings in the wall behind the range and in the fl oor under the range when hookups are completed. 

There are separate ignition devices for the left and right hand surface burners. Both of these ignitors are ON when any 

knob is turned to the LITE setting. The ignitors will spark as long as any of the top burner knobs are at the LITE setting. 

In the event of an electrical power failure, the top burners can still be used. To light a burner, hold a lit kitchen match adja-

cent to the top burner to be used and turn valve knob to LITE. USE EXTREME CAUTION. 

The oven burner fl ame should be a clean, blue fl ame with distinct inner cones approximately 1/2 inch long. A soft, lazy 

fl ame with indistinct cones means too much gas or not enough air. A noisy lifting fl ame means too much air. 

The fl ame should have approximately 1-inch blue cones. After 30 seconds of burner operation, check for fl ames lifting off 

the burner ports. If lifting is observed, gradually reduce the air shutter opening until fl ames are stabilized. Some yellow 

tipping may be normal for LP gas. 

If Adjustment is Necessary: 

A: Loosen the lock screw located at the top of the air shutter, then rotate the air shutter to the correct setting and retighten 

the screw. 

B: Oven burner fl ame can be checked as follows (without burner baffl e in place)

• 

To correct a yellow fl ame, increase size of air shutter opening

• 

To correct a lifting, but distinct, blue fl ame - Decrease size of air shutter opening. 

C: The air shutter should be set approximately 2/3 open for natural gas, and approximately full open for LP gas. 

D: The oven burner air shutter adjustment is the same on ranges with a gas pilot or electric ignition. 

/ODPDVD]XOHV
*DVQDWXUDO

4XHPDGRU

SDUDKRUQHDU

DVDU





&RQRLQWHUQR

GHODOODPD
*DV/3

Blue fl ames

Gas natural

Inner cone of 

fl ame 

 LP Gas

Bake/broil 

burner

J

/RRVHQ
ORFN
VFUHZ

$LUVKXWWHU

Loosen lock 

screw

Air shutter

28