Maytag MVWX655DW Installationsanweisungen

Secure drain hose to laundry tub leg, drain standpipe, or inlet 

hoses for wall standpipe with cable tie.

IMPORTANT: Level washer properly to reduce excess noise  

and vibration.

Move the washer to its final location. Place a level on top 

edges of washer. Use side seam as a guide to check levelness 

of sides. Check levelness of front using lid, as shown. Rock 

washer back and forth to make sure all four feet make solid 

contact with floor. If washer is level, skip to step 15, (on 

models with metal feet) or step 16 (on models with plastic 

feet). 

Place level here

Place level here

Not Level

Not Level

Laundry Tub

Standpipe

Wall

If washer is not level:
On models with metal feet, use a 9/16" or 14 mm open-end or 

adjustable wrench to turn jam nuts clockwise on feet until they 

are about 1/2" (13 mm) from the washer cabinet. Then turn the 

leveling foot clockwise to lower the washer or counterclockwise 

to raise the washer.
On models with plastic feet, use adjustable pliers to turn the 

plastic leveling foot counterclockwise to lower the washer or 

clockwise to raise the washer. On all models, recheck levelness 

of washer and repeat as needed. 

HELPFUL TIP: You may want to prop up front of washer 

about 4" (102 mm) with a wood block or similar object that  

will support weight of washer.

On models with metal feet, when washer is level, use a  

9/16" or 14 mm open-end or adjustable wrench to turn jam 

nuts counterclockwise on leveling feet tightly against washer 

cabinet. 
HELPFUL TIP: You may want to prop washer with  

wooden block.

Jam nut

Jam nut