Whirlpool XHPC155YBD Installationsanweisungen

note: If the washer is to be transported, call your local service 

center. To avoid suspension and structural damage, your  

washer must be properly set up for relocation by a certified  

technician.

1.  Turn off the hot and cold water faucets. 
2.  Unplug the power supply cord. 
3.   Slowly loosen the fill hoses at the faucets to relieve the water 

pressure. Use a sponge or towel to absorb the released water.

4.   Remove the “HOT” and “COLD” fill hoses from the back of 

the washer. Drain the water from the hoses into a bucket. 

 5.   Remove the drain hose from the standpipe or laundry tub and 

drain any water remaining in the hose into a bucket.

6.   Pull the washer away from the wall so that you will have 

enough space for the installation. 

Open the pedestal drawer as far as possible and remove the 

contents. The package contains four #12 x 3/4" hex-head  

sheet metal screws and a drawer divider.

ImPoRtant: Set the pedestal box aside for use during  

installation. 

Using a 1/4" nut driver, remove the hex-head screws from both 

drawer slides and save screws. Remove the drawer from the 

slides and set aside. Push the slides back into the pedestal.

ImPoRtant:  If your washer and dryer are already installed,  

they must be uninstalled.

To avoid possible damage to the washer, the transport bolts on 

the back of the washer must be in place before installing the 

pedestal. For more information on transport bolts see, “Remove 

Transport System” in washer Use and Care Guide.

The four spacer pads are installed on the top of the pedestal. 

These pads reduce vibration between the pedestal and the 

washer/dryer.
note: If your washer/dryer has feet installed, remove them.