Maytag MDE25PRAYW Installationsanweisungen
15
C
B
A
D
1. Remove center, silver-colored terminal
block screw.
2. Remove neutral ground wire from
external ground conductor screw.
Connect neutral ground wire and the
neutral wire (white or center wire) of
power supply cord under center,
silver-colored terminal block screw.
Tighten screw.
Connect neutral ground wire and the
neutral wire (white or center wire) of
power supply cord under center,
silver-colored terminal block screw.
Tighten screw.
IMPORTANT: A 4-wire connection is
required for mobile homes and where local
codes do not permit the use of 3-wire
connections.
required for mobile homes and where local
codes do not permit the use of 3-wire
connections.
Power supply cord,
4-wire connection:
4-wire connection:
A. 4-wire receptacle (NEMA type 14-30R)
B. 4-prong plug
C. Ground prong
D. Neutral prong
E. Spade terminals with upturned ends
F. 3/4" (19 mm) UL listed strain relief
G. Ring terminals
B. 4-prong plug
C. Ground prong
D. Neutral prong
E. Spade terminals with upturned ends
F. 3/4" (19 mm) UL listed strain relief
G. Ring terminals
A. External ground conductor screw - Dotted line shows position of
NEUTRAL ground wire before being moved to center silvercolored
terminal block screw.
terminal block screw.
B. Center, silver-colored terminal block screw
C. Neutral ground wire
D. Neutral wire (white or center wire)
E. 3/4" (19 mm) UL listed strain relief
C. Neutral ground wire
D. Neutral wire (white or center wire)
E. 3/4" (19 mm) UL listed strain relief
A. External ground conductor screw
B. Ground wire (green or bare) of power supply cord
C. 3/4" (19 mm) UL listed strain relief
D. Center, silver-colored terminal block screw
E. Neutral ground wire
F. Neutral wire (white or center wire)
B. Ground wire (green or bare) of power supply cord
C. 3/4" (19 mm) UL listed strain relief
D. Center, silver-colored terminal block screw
E. Neutral ground wire
F. Neutral wire (white or center wire)
3.
Connect ground wire (green or bare) of
power supply cord to external ground
conductor screw. Tighten screw.
power supply cord to external ground
conductor screw. Tighten screw.
5. Tighten strain relief screws.
6. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover
with holddown screw.
with holddown screw.
7. You have completed your electrical
connection. Now go to “Venting
Requirements.”
Requirements.”
4. Connect the other wires to outer terminal
block screws. Tighten screws.
E
F
G
C
B
A
D
E
F
C
B
A
D
E
W10135154B EnFrv10.qxd:YB70809-10135134A 4/20/10 2:42 PM Page 15