Whirlpool CAE2793BQ Installationsanweisungen

Drain

hose form

Proper routing of the drain hose avoids damage to your floor  

due to water leakage. 

1. Remove tape from the washer drain port on the back of   

  the washer.

2. If clamp is not already in place on elbow end of drain hose,  

  slide it over end as shown. 

3. Squeeze clamp with pliers and slide elbow end of drain  

  hose onto washer drain port and secure with clamp.

4. The washer drain system can be installed using a floor drain,  

  wall standpipe, floor standpipe, or laundry tub.

5. Place hose into standpipe (shown in picture) or over side  

  of laundry tub.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside 

standpipe; do not force excess hose into standpipe or lay  

on bottom of laundry tub. Drain hose form must be used.

6. For floor drain installations, you will need to remove the drain  

  hose form from the end of the drain hose. You may need  

  additional parts with separate directions. See “Tools and Parts.”

7. The floor drain system requires a siphon break that may be    

  purchased separately. The siphon break (Part Number 285834)  

  must be a minimum of 28" (710 mm) from the bottom of the    

  washer. Additional hoses might be needed.