Maytag MHW5100D Benutzung Und Pflege

Seite von 48
12
WASHER CARE
Recommendations to Help Keep Your Washer Clean 
and Performing at its Best
1.   Always use High Efficiency (HE) detergents and follow the 
HE detergent manufacturer’s instructions regarding the 
amount of HE detergent to use. Never use more than the 
recommended amount because that may increase the rate 
at which detergent and soil residue accumulate inside your 
washer, which in turn may result in undesirable odor.
2.    Use warm or hot water washes sometimes (not exclusively  
cold water washes), because they do a better job of controlling 
the rate at which soils and detergent accumulate.
3.    Always leave the washer door slightly ajar between uses  
to help dry out the washer and avoid the buildup of  
odor-causing residue.
4.   Periodically clean residue from the underside of the glass 
window.
Cleaning Your Front Loading Washer
Read these instructions completely before beginning the 
routine cleaning processes recommended below. This Washer 
Maintenance Procedure should be performed, at a minimum, 
once per month or every 30 wash cycles, whichever occurs 
sooner, to control the rate at which soils and detergent may 
otherwise accumulate in your washer.
Cleaning the Door Seal
1.   Open the washer door and remove any clothing or items from 
the washer.
2.   Inspect the colored seal between the door opening and the 
drum for stained areas or soil buildup. Pull back the seal 
to inspect all areas under the seal and to check for foreign 
objects.
3.   If stained areas or soil buildup are found, wipe down these 
areas of the seal using either of the following two procedures:
  a. affresh
®
 Grit Grabber™ Cloth Procedure:
    i.   When the cycle is complete, gently pull back the rubber 
door seal and clean the entire surface with the rough 
side of the Grit Grabber™ cloth.
  b.  Dilute Liquid Chlorine Bleach Procedure:
    i.   Mix a dilute bleach solution, using 3/4 cup (177 mL) of 
liquid chlorine bleach and 1 gallon (3.8 L) of warm tap 
water.
      ii.   Wipe the seal area with the dilute solution, using  
a damp cloth.
     iii.   Let stand 5 minutes.
     iv.   Wipe down area thoroughly with a dry cloth and let 
washer interior air dry with door open.
  IMPORTANT:
  n Wear rubber gloves when cleaning with bleach.
  n  Refer to the bleach manufacturer’s instructions for 
proper use.
WASHER MAINTENANCE
Replace inlet hoses after 5 years of use to reduce the risk of 
hose failure. Periodically inspect and replace inlet hoses if 
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement 
on the label with a permanent marker.
WATER INLET HOSES
WASHER CARE (cont.)
Cleaning the Inside of the Washer
This washer has a special cycle that uses higher water volumes 
in combination with affresh
®
 Washer Cleaner or liquid chlorine 
bleach to thoroughly clean the inside of the washer. Steam 
washer models also utilize steam to enhance cleaning in this 
special cycle.
NOTE: Read these instructions completely before beginning the 
cleaning process.
Begin procedure
1.   Clean Washer with affresh
®
 Cycle Procedure 
(Recommended for Best Performance):
  a.   Open the washer door and remove any clothing or items.
  b.   Add an affresh
®
 Washer Cleaner tablet to the washer 
drum.
  c.   Do not add the affresh
®
 Washer Cleaner tablet to the 
dispenser drawer.
  d.   Do not add any detergent or other chemical to the washer 
when following this procedure.
  e.   Close the washer door.
  f.  Select the Clean Washer with affresh
®
 cycle.
  g.  On some models: Select the Fresh Hold
®
/Fresh Spin
 
option to help dry the washer interior after the cycle is 
complete. NOTE: The washer remembers your last option 
selection and will use it for future wash cycles until you 
deselect that option. While the fan is on, the washer door 
will lock. To unlock the door, touch POWER/CANCEL.
  h.   Touch and hold START to begin the cycle. The Clean 
Washer with affresh
®
 Cycle Operation is described below.
2.  Chlorine Bleach Procedure:
  a.   Open the washer door and remove any clothing  
or items.
  b.   Open the dispenser drawer and add liquid chlorine bleach 
to the MAX level in both the bleach compartment and 
the fabric softener compartment. Either traditional or HE 
chlorine bleach can be used.
  NOTE: Use of more liquid chlorine bleach than is  
  recommended above could cause washer damage  
  over time.
  c.  Close the washer door and the dispenser drawer.
  d.   Do not add any detergent or other chemicals to the 
washer when following this procedure.
  e.  Close the washer door.
  f.  Select the Clean Washer with affresh
®
 cycle.
  g.  On some models: Select the Fresh Hold
®
/Fresh Spin
 
option to help dry the washer interior after the cycle is 
complete. NOTE: The washer remembers your last option 
selection and will use it for future wash cycles until you 
deselect that option. While the fan is on, the washer door 
will lock. To unlock the door, touch POWER/CANCEL.
  h.   Touch and hold START to begin the cycle. The Clean 
Washer with affresh
®
 Cycle Operation is described below.
  NOTE: For best results, do not interrupt cycle.