Amana AGR4230BAW Installationsanweisungen

3. Determine and mark centerline of the cutout space. The 

mounting can be installed on either the left side or right side 
of the cutout. Position mounting bracket against the wall in 
the cutout so that the V-notch of the bracket is 9

⁵⁄₈" (24.6 cm) 

from centerline as shown.

4. Drill two 

¹⁄₈" (3 mm) holes that correspond to the bracket 

holes of the determined mounting method. See the following 
illustrations.

5. Using the Phillips screwdriver, mount anti-tip bracket to the 

wall or floor with the two #12 x 1

⁵⁄₈" (4.1 cm) screws provided.

6. Move range close enough to opening to allow for final gas 

and electrical connections. Remove shipping base, 
cardboard or hardboard from under range.

7. Move range into its final location, making sure rear leveling 

leg slides into anti-tip bracket.

8. Move range forward onto shipping base, cardboard or 

hardboard to continue installing the range using the following 
installation instructions.

1. Apply pipe-joint compound made for use with LP gas to the 

smaller thread ends of the flexible connector adapters (see B 
and F in the following illustration).

2. Attach one adapter to the gas pressure regulator and the 

other adapter to the gas shutoff valve. Tighten both adapters, 
being certain not to move or turn the gas pressure regulator.

3. Use a 

¹⁵⁄₁₆" (2.4 cm) combination wrench and an adjustable 

wrench to attach the flexible connector to the adapters.

IMPORTANT: All connections must be wrench-tightened. Do 
not make connections to the gas regulator too tight. Making 
the connections too tight may crack the regulator and cause 
a gas leak. Do not allow the regulator to turn when tightening 
fittings.   

⁵⁄₈

Centerline

B

A

C

E

G

H

A

D

F

B