Maytag MHW8100DC Benutzeranleitung

Operation:
1.   The Clean Washer with affresh

® 

cycle will determine whether 

clothing or other items are in the washer.

2.   If no items are detected in the washer, it will proceed  

with the cycle.

  a.   If any items are detected in the washer, “rL” (remove load) 

will be displayed. The door will unlock. Open washer and 

remove any garments from the washer drum.

  b.  Touch POWER/CANCEL to clear the “rL” code.
  c.  Touch and hold START to restart the cycle.
3.    Steam models only: During the first 20 minutes of the 

cycle, it will activate the steamer but the drum will not spin or 

fill with water. You may see condensation on the door glass 

during this initial phase. If you are using an affresh

®

 Washer 

Cleaner tablet, it will not dissolve completely during the 

steam phase. This is normal.

After the cycle is complete, leave the door open slightly to allow 

for better ventilation and drying of the washer interior.
Cleaning the Dispensers
After a period of using your washer, you may find some residue 

buildup in the washer’s dispensers. To remove residue from the 

dispensers, remove the drawer and wipe the surfaces with a 

damp cloth and towel dry either before or after you run the Clean 

Washer with affresh

®

 cycle. Use an all-purpose surface cleaner, 

if needed.
IMPORTANT: Dispenser is not dishwasher safe.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe up any spills. 

Occasionally wipe the outside of your washer to help keep it 

looking new. Use mild soap and water. 
IMPORTANT: To avoid damaging the washer’s finish, do not 

use abrasive products.

3.  Lift off cover panel by 

pulling straight up.

To replace:
1.  Slide cover panel back  

onto posts on dispenser. 

2.  Align edges of dispenser  

with guides in washer,  

then slide dispenser  

back into slot. 

To remove:
1.  Pull dispenser drawer out until it stops.
2.  Press down on the release tab and pull straight out to 

remove the dispenser. 

NOTE: Not all models have the Clean Washer with affresh

®

 

cycle reminder light.
The Clean Washer with affresh

®

 

LED will flash at the end of a 

wash cycle when the washer has 

run 30 wash cycles. This is a 

reminder to run the Clean Washer with affresh

®

 cycle. 

If the Clean Washer with affresh

®

 cycle is not turned on, the LED 

will stop flashing at the end of a wash cycle after running 3 more 

regular wash cycles. After 30 more wash cycles are completed, 

the Clean Washer with affresh

®

 LED will again flash at the end 

of a wash cycle as a reminder.