Maytag MGD7100D Installationsanweisungen

 

■

A location allowing for proper exhaust installation.  

See “Venting Requirements.”

 

■

A separate 15 or 20 amp circuit for a gas dryer or 30 amp 

circuit for an electric dryer.

 

■

If using power supply cord, a grounded electrical outlet  

located within 2 ft. (610 mm) of either side of dryer.  

See “Electrical Requirements.”

 

■

Floor must support dryer weight of 200 lbs. (90.7 kg).  

Also consider weight of companion appliance.

 

■

Cold water faucets located within 4 ft. (1.2 m) of the water  

fill valves, and water pressure of 20 – 120 psi (138 – 827 kPa). 

You may use the water supply for your washer using the 

supplied “Y” connector and a short hose (which you will  

need to purchase).

 

■

Level floor with maximum slope of 1" (25 mm) under entire 

dryer. If slope is greater than 1" (25 mm), install Extended  

Dryer Feet Kit, Part Number 279810. If not level, clothes  

may not tumble properly and automatic sensor cycles may  

not operate correctly.

 

■

For garage installation, place dryer at least 18" (460 mm)  

above floor. If using a pedestal, you will need 18" (460 mm)  

to bottom of dryer.

 

■

The dryer must not be installed or stored in an area where  

it will be exposed to water and/or weather.

IMPORTANT: Do not operate, install, or store dryer where  

it will be exposed to water, weather, or at temperatures below  

40° F (4° C). Lower temperatures may cause dryer not to  

shut off at end of automatic sensor cycles, resulting in longer  

drying times.

/

/

/

/

/

/

/

/

/

NOTE: Most installations require a minimum of 5" (127 mm) 

clearance behind dryer for exhaust vent with elbow. See  

“Venting Requirements.”

* Approx. measurement 

Gas

* Approx. measurement

Water inlet  

(Steam Models Only)

Vent