Maytag MHW7100D Benutzung Und Pflege

If you experience

Possible Causes

Solution

First try the solutions suggested here or visit our website at www.maytag.com/product_help –

In Canada www.maytag.ca for assistance and to possibly avoid a service call.

Error Code Appears in Display

“Sud”

(Excess suds)

appears in display

Excessive suds in washer. Washer is

running a suds reduction routine.

Allow the washer to continue. Use only HE detergent.

Always measure detergent, and base detergent quantity on

load size. Follow detergent manufacturer’s instructions.

Touch POWER/CANCEL once to clear the code. Then touch

POWER/CANCEL again to restart washer. If code appears again,

call for service.

F08

followed by

E01

(water supply error)

appears in display

Check for proper water supply.

Both hoses must be attached and have water flowing to the inlet

valve.
Both hot and cold water faucets must be on.
Inlet valve screens on washer may be clogged.
Remove any kinks in the inlet hose.

F09

followed by

E01

(drain pump system

error) appears in display

Check plumbing for correct drain

hose installation. Drain hose extends into

standpipe farther than 4

⁄

" (114 mm).

Check drain hose for proper installation.
Make sure the drain hose is not kinked, pinched, or blocked.
Remove any clogs from drain hose.
Use drain hose form and securely attach to drainpipe or tub.
Lower drain hose if the end is higher than 96" (2.4 m) above

the floor.

F05

followed by

E02

(door will not lock)

appears in display

Washer door not locking.

Touch POWER/CANCEL to cancel the cycle. Make sure the door

is closed completely and latching. Check for items in the washer

drum that may be keeping the door from closing completely.

Washer beeps when

START is touched

Door not closed.

Close the door completely.

“rL”

(remove load)

appears in display

Load detected in drum during Clean

Washer with affresh

cycle.

Remove items from washer drum and restart Clean Washer with

affresh

cycle.

Washer making error

beeps

Door has not been opened and closed

for at least 3 cycles.

This code may appear when the washer is first turned on.

Open and close the door to clear the display.

Once any possible issues are corrected, touch POWER/CANCEL once to clear the code. Reselect and restart the cycle.

## E##

code other

than as described above

appears in display

System error code.

Touch POWER/CANCEL once to clear the code. Then touch

POWER/CANCEL again to restart washer. If code appears again,

call for service.

Not using HE detergent or using too

much HE detergent.

Use only HE detergent. Always measure detergent and follow

manufacturer’s directions based on load size and soil level.

TROUBLESHOOTING

“Int” (interrupted)

appears in display

The cycle was paused or cancelled.

The washer can take 20 to 30 minutes to stop spinning and drain

and will display this error code during that time. Touch POWER/

CANCEL once to clear the code. Then touch POWER/CANCEL

again to restart washer.

Clean Washer LED

flashing at end of wash

cycle

The washer has run 30 wash cycles and

is indicating a reminder to run the Clean

Washer with affresh

cycle.

Run the Clean Washer with affresh

cycle. If the Clean Washer with

affresh

cycle is not turned on, the LED will stop flashing at the end

of a wash cycle after running 3 more regular wash cycles. After 30

more wash cycles are completed, the Clean Washer LED will again

flash at the end of a wash cycle as a reminder.