Maytag MHW8100D Dimensionale Illustrationen

Because Whirlpool Corporation policy includes a continuous commitment to improve 

Dimensions are for planning purposes only. For complete details, see Installation 

our products, we reserve the right to change materials and specifications without notice. 

Instructions packed with product. Specifications subject to change without notice.

A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is 

recommended that a separate circuit serving only this appliance be provided.

Floor drain system requires a Siphon Break Kit (Part Number 

285834), 2 Connector Kits (Part Number 285835), and an  

Extension Drain Hose (Part Number 285863) that may be  

purchased separately. See “Alternate Parts”. Minimum siphon 

break height: 28" (710 mm) from bottom of washer. (Additional 

hoses may be needed.)

Minimum diameter for a standpipe drain: 2" (51 mm). Minimum 

carry-away capacity: 17 gal. (64 L) per minute. A 1/4" (6 mm)  

diameter to 1" (25 mm) diameter Standpipe Adapter Kit is  

available (Part Number 3363920). Top of standpipe must be at  

least 30" (762 mm) high; install no higher than 96" (2.44 m) from 

bottom of washer. If you have an overhead sewer and need to 

pump higher than 96" (2.44 m), a sump pump and associated  

hardware are needed. See “Alternate Parts”.

Minimum capacity: 20 gal. (76 L). Top of laundry tub must  

be at least 30" (762 mm) above floor; install no higher than  

96" (2.44 m) from bottom of washer. 

See requirements for floor standpipe drain system.

Drain system can be installed using a floor drain, wall standpipe,  floor standpipe, or laundry tub. Select method you need. 

 To avoid siphoning, only 4.5" (114 mm) of drain hose should be inside standpipe. Always secure drain hose 

with cable tie.

 

Recommended 4" (102 mm), minimum 1.5" (38 mm)

All dimensions show recommended spacing allowed, except for 

closet door ventilation openings which are the minimum required.
For each arrangement, consider allowing more space for ease of 

installation and servicing, and spacing for companion appliances 

and clearances for walls, doors, and floor moldings. 
Space must be large enough to allow door to fully open.  

Add spacing of 1" (25 mm) on all sides of washer to reduce  

noise transfer. If a closet door or louvered door is installed, top 

and bottom air openings in door are required.