Frigidaire FGMC2765PF Installationsanweisungen

4

MICROWAVE/ WALL OVEN COMBINATION

INSTALLATION INSTRUCTIONS

Model and Serial Number Location

The serial plate is located along the interior side trim of 
the oven and visible when the door is opened.

When ordering parts for or making inquires about your 
oven, always be sure to include the model and serial 
numbers and a lot number or letter from the serial plate 
on your oven.

Serial Plate 
Location

where local codes DO NOT permit grounding through 
the neutral (white) wire, the appliance frame MUST 
NOT be connected to the neutral wire of the 4-wire 
electrical system. (see fi gure 4): 
1.  Disconnect the power supply.
2.  Separate the green (or bare copper) and white 

appliance cable wires.

3. In the junction box:
  Connect appliance and power supply cable wires as 

shown in Figure 4.

Figure 4

4-WIRE GROUNDED JUNCTION BOX

Cable from Power Supply

White Wire

Junction Box

Cable from appliance

White Wire

Black 

Wires

Red

Wires

Ground Wire

Ground Wire

(Bare or Green 

Wire)

U.L.-Listed 

Conduit Connector 

(or CSA listed)

Figure 5

4. Cabinet Installation

1.  Unpack the wall oven. Remove the bottom trim 

taped on the oven side panel.

2.  Find the 2 anti-tip mounting screws included in the 

oven cavity.

3.  Insert the oven into the cabinet opening. Slide oven 

inward leaving 1½" (3.8 cm) clearance between the 
oven and front of cabinet (see Figure 5).

4.  Pull the armored cable through the hole for it in the 

cabinet and toward the junction box while moving 
the appliance inward. 

5.  Push the oven in and against the cabinet.

1½" (3.8 cm)
clearance 
between unit 

Heavy Weight Hazard

• 

Use 2 or more people to move and install wall 
oven.

• 

Failure to follow this instruction can result in injury 
or damage to the unit.

IMPORTANT NOTE

Do not lift the oven by the door handle.