GE AVM4160DFBS Installationsanweisungen

1  Remove the blower motor screws that holds the blower 

plate to the microwave oven. Slide the plate toward the 

back of the microwave and lift up to remove.

  Remove screw on the back of the unit.

‡  Read the instructions on the TOP CABINET 

TEMPLATE.

‡  Tape it underneath the top cabinet.
‡  Drill the holes, following the instructions on the 

TOP CABINET TEMPLATE.

Wall

Mounting 

Plate

Spacing for Toggles More 

Than Wall Thickness

Toggle  

Bolt

Toggle Wings

Bolt 

End

You need to drill holes for the top support screws and  

a hole large enough for the power cord to fit through.

  Place the mounting plate against the wall and insert 

the toggle wings into the holes in the wall to mount 

the plate.

NOTE: Before tightening toggle bolts and wood screw, 

make sure the tabs on the mounting plate touch  

the bottom of the cabinet when pushed flush against 

the wall and that the plate is properly centered under 

the cabinet.

  Tighten all bolts. Pull the plate away from the wall  

to help tighten the bolts.

Blower Plate

Blower Motor Screws

  The fan needs to be turned 180 degrees to the right 

to be in the correct orientation, keeping the  blower 

part of the fan where the air comes out at the top 

of the fan.  The wire needs to be reinsterted into the 

cage housing once it has been oriented correctly.

Back of Microwave

Fan Blades

Wires

TO THE WALL cont

Screw

  Carefully remove fan from cavity. Remove the wire 

from the notch at the bottom of the fan after it is 

removed from the cavity.

    Remove the knockout plates in the back of the unit 

with snips.  

Back of mircrowave

Knockout Plates:

Snip all 4 webs on 

each knockout panel 

and remove the metal 

knockouts for rear airflow. 

Please take care to 

remove any sharp edges 

created from removing 

the knockout plates.