Amana AGR5630B Anleitung Für Quick Setup

1. Light 1 burner and turn to lowest setting.
2. Remove the control knob.

Hold the knob stem with a pair of pliers. Use a small flat-blade 
screwdriver to turn the screw located in the center of the 
control knob stem until the flame is the proper size.

3. Replace the control knob.
4. Test the flame by turning the control from “LO” to “HI,” 

checking the flame at each setting.

5. Repeat the above steps for each burner.

1. Remove the oven rack. 
2. To remove the oven bottom: Remove 2 screws at the rear of the 

oven bottom. Lift the rear of the oven bottom up and back until 
the front of the panel is away from the front frame. Remove 
from oven and place on a covered surface.

3. You can check the burner flame by removing the flame 

spreader or by using a mirror.
Remove flame spreader:
Remove 2 screws from the front tabs of the flame spreader. Lift 
front of the flame spreader and pull forward to remove tabs 
from rear of oven.

Using a mirror:
Insert a mirror to one side of the burner. Look into the mirror to 
check flame.

4. Push the BAKE pad.
5. Press the START pad. 
The oven bake burner should light within 8 seconds. Under certain 
conditions, it may take the burner up to 50 to 60 seconds to light. 
Electronic igniters are used to light the bake and broil burners.
Refer to the Use and Care Guide or User Instructions for proper 
operation of the oven controls. 

1. On models with a warming drawer, remove access cover plate 

(1 screw) located at the back of the warming drawer 
compartment.

2. Check the oven bake burner for proper flame. 

This flame should have a ½" (1.3 cm) long inner cone of bluish-
green, with an outer mantle of dark blue, and should be clean 
and soft in character. No yellow tips, blowing or lifting of flame 
should occur.

3. If the oven bake flame needs to be adjusted, locate the air 

shutter near the center rear of the range. Loosen the locking 
screw and rotate the air shutter until the proper flame appears. 
Tighten locking screw.

4. Push CANCEL/OFF when finished. 
5. Reinstall flame spreader and oven bake burner cover.

1. Close the oven door.
2. Press the BROIL pad.
3. Press the START pad.
The oven burner should light within 8 seconds. Under certain 
conditions, it may take the burner up to 50 to 60 seconds to light. 
Refer to the Use and Care Guide or User Instructions for proper 
operation of the oven controls.

Look through oven window to check broil burner for proper flame. 
This flame should have a ½" (1.3 cm) long inner cone of bluish-
green, with an outer mantle of dark blue, and should be clean and 
soft in character. No yellow tips, blowing or lifting of flame should 
be present.

A

B

C

A

B

A

B

C

D

A

B