Maytag MED4200BG Installationsanweisungen

Using a TORX T25 screwdriver, remove the 4 screws securing 

the door hinge to the dryer and lift up and out to remove the 

door. Place the door on a soft towel or other non-scratch 

surface. Retain or set aside the 4 screws.

Using a TORX T25 screwdriver, remove the 2 screws securing 

the door strike to the door frame of the dryer. Remove the  

4 screws above and below the door strike and set aside for 

later use. Rotate the strike 180° and attach to the opposite 

side of dryer door frame, as shown. 

Position the door with the inside of the door facing up. Using 

a Phillips screwdriver, remove the 13 screws securing the 

inner door to the outer door. Lift off the inner door and set 

aside. 

NOTE: There is a small release tab on each side of the door.  

If the inner and outer door do not separate easily, slide a  

credit card, putty knife, or similar flat object between the inner  

and outer doors at the locations shown to release the tab.

Using a TORX

®

 T25 screwdriver, remove the 4 screws on the 

dryer. Insert the tabs on the hinge into the mounting slot and 

slide down to engage the top tab. Secure in place with  

the 4 TORX T25 screws removed earlier.