Maytag MED6000AG Benutzung Und Pflege

Possible Causes

Solution

The drying cycle has been

interrupted by a power failure.

Touch and hold START to restart the dryer. NOTE: The Control

Lock function may be enabled when recovering from a power

failure. To unlock the control, touch and hold CONTROL LOCK

for at least 3 seconds.

There may be a problem with your

home power supply, keeping the

dryer’s heater from turning on.

The dryer will continue to run when this diagnostic code is present.

Touch any pad to clear the code from the display and return to the

estimated time remaining.

Try the following:
Check to see if a household fuse has blown or circuit breaker

has tripped. Electric dryers use two household fuses or breakers.

Replace the fuse or reset the circuit breaker.

Confirm that the power cord is properly installed. Refer to

the Installation Instructions for details.

Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, consult a qualified electrician.

“L2” Diagnostic Code

(low or no line voltage

condition)

The lint screen or vent is clogged;

the vent is crushed or kinked or has

too many turns.

The dryer will continue to run when this diagnostic code is present.

Touch any key to clear the code from the display and return to the

estimated time remaining.

Try the following:
• Clean lint screen.
• Check to see if the vent run from the dryer to the wall is

crushed or kinked.

• Confirm that the vent run from the dryer to the wall is free

of lint and debris.

Confirm that the exterior vent exhaust hood is free of lint

and debris.

Confirm that your vent system falls within the recommended

run length and number of elbows for the type of vent you are using.

Refer to “Plan Vent System” in the Installaton Instructions for details.

Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, have your entire home venting run cleaned.

“Check Vent” cycle

status indicator lights

up (blocked vent or low

airflow condition)

“PF” (power failure)

The dryer is in need of service.

If a code beginning with an “F” appears in the display,

alternating between F# and E#, the dryer control has

detected a problem that requires service. Call for service.

Dryer Displaying Code Message or Cycle Status Indicator Lights Up

Dryer Results (cont.)

Load removed before cooldown

portion of cycle complete.

Allow the dryer to complete the cooldown portion of the cycle

before removing the load.

Load too hot

Using Timed Dry cycle with a high

temperature setting.

Select a Sensor cycle with a lower heat setting to avoid overdrying

the load.

Odors

Recent painting, staining, or

varnishing in the area where

your dryer is located.

Ventilate the area. When the odors or fumes are gone from the

area, rewash and dry the clothing.

For steam cycles, the water is not

properly connected with the dryer.

Make sure water is connected to the dryer. Check that water

inlet hose is connected to both the faucet and dryer’s water inlet

valve. Check that the water supply is turned on.

Odors are left in garments after

wearing.

To remove odors left in garments after wearing, select Custom

Refresh. This cycle is best for reducing wrinkles and odors from

dry loads consisting of wrinkle-free cotton, cotton-polyester

blends, common knits, and synthetics.

“F# E#” (F1 E1, F3 E1, etc.)

variable service codes.

First try the solutions suggested here or visit our website at www.maytag.com/product_help –

In Canada www.maytag.ca for assistance and to possibly avoid a service call.

If you experience