Dacor DR30EFS Designanleitung

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

™

Document # PG05-008

Revised 11/09/12   Page 1/4

•  Observe all governing codes and ordinances during planning 

and installation. Contact your local building department for 

further information. 

•  This appliance must be installed in accordance with the 

accompanying installation instructions.

All tolerances ±1/16” (±1.6 mm) unless otherwise noted.

ADRB30E03

3 Inch

Optional on all models

ADRB30E06

6 Inch

Standard on models DR30ES, DR30EFS

Optional on models DR30EIS, DR30EIFS

ADRB30E09

9 Inch

Optional on all models

Models DR30EIS and DR30EIFS come equipped from the factory with 

flat stainless trim piece in place of a backguard. A backguard may be 

purchased as an optional accessory.

The trim on models DR30ES and DR30EFS are not compatible 

with a raised vent.
Models DR30EIS and DR30EIFS are compatible with Dacor 

raised vent models ERV3015. Use only theses specified raised 

vent models.

A

46 1/8” (117.2 cm)

46” (116.8 cm)

B

27 3/4” (70.5 cm)

27 5/8” (70.2 cm)

C

25 3/8” (64.5 cm)

25 1/4” (64.1 cm)

D

23 1/4” (64.1 cm)

23 1/8” (58.7 cm)

DR30ES

Freestanding,  

(full size side panels)

Mounted on

outside of door

DR30ES-C*

Freestanding,  

(full size side panels)

Mounted on

outside of door

DR30EFS

Freestanding,  

(full size side panels)

Flush handle,

integrated in door

DR30EFS-C*

Freestanding,  

(full size side panels)

Flush handle,

integrated in door

DR30EIS

Built-in/Slide-in 

(3 1/4” removable side panels)

Mounted on

outside of door

DR30EIFS

Built-in/Slide-in 

(3 1/4” removable side panels)

Mounted on

outside of door

* -C indicates Canadian wiring configuration, see page 3/4 for details.

1” (2.5 cm)

Front of open door
Front of handle/knobs
Front panel
Rear of front panel

Backguard thickness

3” (7.6 cm)

backguard*

External handle 

shown, some models 

have integral handle

(see inside cover)

6” (15.2 cm)

backguard*

*

See table for compatibility

Product width:

29 15/16” (76.0 cm) 

35”

(88.9 cm)

to

37”

(94.0 cm)

9” (22.9 cm)

Backguard*

A

B

C

D

DR30EI[F]S:

3/8” (9.5 mm)

DR30E[F]S:

Full stainless 

steel side panels

DR30EI[F]S:

3” (7.6 cm)

partial stainless 

steel side panels

(removable)