Dacor DR30DH Designanleitung

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

Document # PG05-006

Revised 01/30/13   Page 4/6

Countertop Self-

Rimmed Only

21”

(53.3 cm)

0” (0 cm) to

3 1/4” (8.3 cm)

0” (0 cm) to

5 3/8” (13.7 cm)

Countertop and

Cabinet Front

Self-Rimmed

1

24 1/4”

(61.6 cm)

NA

0” (0 cm) to

2 1/8” (5.4 cm)

1

 Side panels removed

Countertop height for all self-rimming installations:  

35 7/16” (90.0 cm) minimum, 37 7/16” (95.1 cm) maximum

 

■

See following pages for raised vent installations.

 

■

Only model DR30DI[H] may be installed in a self-rimming 

configuration. Self-rimming installations create a “built-in” look where 

the trim of the range overlaps the surrounding countertop. It is also 

possible, if the cabinets are the right depth, to self rim the front of the 

range into the cabinet face, immediately behind the control panel and 

door trim. When the front of the range is self-rimmed, the 3 1/4” side 

panels are removed.

 

■

When sliding the range into position, it will stop when the rear of the 

side panels or front panel contacts the notches toward the front of the 

countertop. The rear of the range trim will overhang the countertop in 

back.

Cabinet tolerances: -1/16”, (+1.6 mm) -0

Countertop

DR30DI[H] range

H

1/4” min. (6.4 mm)

flat countertop min.

Range trim resting

on countertop

See Top View for required distance

to vertical surfaces

Cabinet face

Back of

cutout

Back of

control

panel
3 1/4 inch

side panel

Cabinet face

Countertop

Back of control

panel and trim

behind door

rest against

cabinet face

DR30DI[H] range

1/4” min. (6.4 mm)

flat countertop min.

Range side

panels removed

Range trim resting

on countertop

See Top View for required distance

to vertical surfaces

H

Back of cutout

countertop opening

29 1/4” (74.3 cm)

30” (76.2 cm)

cabinet opening

below countertop

below countertop

To cabinet face

Notch countertop

overhang to width of

cabinets below

1/4” min.* (6 mm)

 countertop

overhang

10” min.

(25.4 cm)

both sides

To countertop

 front

H

J K

Combustible side

wall above range

Rear wall or other 

vertical surface **

** Any vertical surfaces behind the range must be non-combustible 

unless countertop overhang exceeds 2 3/4” (7.0 cm). 

Countertop height: min: 35 7/16” (90.0 cm) max: 37 7/16” (95.1 cm) 

* When increasing overhang, increase dimension H by same amount.

Rear wall or other 

vertical surface **

** Any vertical surfaces behind the range must be non-combustible 

unless countertop overhang exceeds 2 3/4” (7.0 cm). 

Countertop height: min: 35 7/16” (90.0 cm) max: 37 7/16” (95.1 cm) 

* When increasing overhang, increase dimension H by same amount.

countertop and

cabinet opening

Notch countertop to

29 1/4” (74.3 cm)

below countertop

Cabinet face

30” (76.2 cm)

1/4” min.* (6 mm)

 countertop

overhang

10” min.

(25.4 cm)

both sides

To countertop

 front

H

K

Combustible side

wall above range