Dacor DR30GIFSNGH Designanleitung

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

™

Document # PG05-007

Revised 09/13/12   Page 1/4

•  Observe all governing codes and ordinances during planning 

and installation. Contact your local building department for 

further information. 

•  This appliance must be installed in accordance with the 

accompanying installation instructions.

All tolerances ±1/16” (±1.6 mm) unless otherwise noted.

 AER30GLBG

Low profile (1 3/4 inch)

Standard on models DR30GIS, DR30GIFS

Optional on models DR30GS, DR30GFS

AERB30G03

3 Inch

Optional on models DR30GS, DR30GFS

NOT compatible with models DR30GIS, DR30GIFS

AERB30G06

6 Inch

Standard on models DR30GS, DR30GFS

NOT compatible with models DR30GIS, DR30GIFS

AERB30G09

9 Inch

Optional on models DR30GS, DR30GFS

NOT compatible with models DR30GIS, DR30GIFS

1 1/8” (2.9 cm)

DR30GI[F]S:

1/4” (6.4 mm)

Front of open door
Front of knobs

Front panel

Rear of front panel

Backguard thickness

26 1/8” (66.4 cm)

28 9/16” (72.5 cm)

24” (61.0 cm)

3” (7.6 cm)

backguard*

DR30G[F]S:

Full stainless

steel side panels

DR30GI[F]S:

(removable)

partial stainless

steel side panels

3 1/4” (8.3 cm)

External handle

shown, some models

(see inside cover)

have integral handle

1” above trim

Grates extend

backguard*

6” (15.2 cm)

1 3/4” (4.4 cm) backguard*

*�

See table for compatibility

Product width:

29 7/8” (75.9 cm)

NOTE: Neither version is

compatible with a raised vent.

to

37”

(94.0 cm)

(88.9 cm)

35”

Backguard*

9” (22.9 cm)

45 9/16” (115.7 cm)