Broan PM500SS Installationsanweisungen

1. Decide where the ductwork will run between the hood and the

outside (Refer to Figure 1).

2. A straight, short duct run will allow the hood to perform most

efficiently.

3. Long duct runs, elbows, and transitions will reduce the performance

of the hood. Use as few of them as possible. Larger ducting may

be required for best performance with longer duct runs.

4. Install a roof or wall cap. Connect round metal ductwork to cap

and work back towards hood location. Use duct tape to seal the

joints between ductwork sections.

NOTE: the hood has to be installed, inside the cabinet.
The internal height of cabinet has to be minimum 16”.
The hood should be mounted centered over the cook top burners.

1. Remove the grease filters, push in on the metal latch tab. Tilt

the filters downward and remove (Fig. 2).

2. Take the filters support away moving the 2 lateral locks C (Fig. 3).

3. Cut a hole in the bottom of the cabinet, using the dimensions shown

(Fig. 4).

4. NOTE: For installations where the Power Pack is less than 30”

above cook top, it is recommended that the Power Pack be

mounted into a metal liner or non-combustible material. This will

allow easier cleaning and provide protection to the cabinetry

(Fig.5A).

5. Insert the hood in the cabinet (Fig. 5) or metal liner (Fig. 5A) and

secure with the (4) “C” mounting sheet metal screws.
(Fig. 5 - wood bottom installation; recommended thickness 1/2”-

3/4”).
(For alternate mounting, use machine screws with washers and

nuts. This alternate mounting method needs to be done prior to

installation of metal liner).

6. Replace the filters support.
7. In the Non-Ducted Recirculation Configuration, install the Non-

ducted recirculation Filters before replacing the grease filters (see

section “Non-ducted recirculation filters installation”).

8. Replace the grease filters.
9. Install the switch push button covers supplied in the hardware

package.

Ducted Configuration
1. Take the damper and assemble it onto the hood’s discharge

opening, pressing slightly.

2. Use 6" round metal duct to connect the discharge collar on the

hood to the ductwork above.

3. Use duct tape to make all joints secure and air tight.

Non-Ducted Recirculation Configuration
1. Connect a 6” round metal duct to the discharge opening so

that the air is sent outside the cabinet and sent back into the

room.

2. Use duct tape to make all joints secure and air tight.

Install the Non-ducted recirculation filters over the grease filters and
secure them with the metal clips supplied with the Non-ducted
recirculation Filters (Fig. 6).

1. Remove the wiring box cover. Remove a knockout from the wiring

box.

2. Secure the conduit to the wiring box through a conduit connector.
3. Make electrical connections. Connect white to white, black to black

and green to green.

4. Replace wiring box cover and screws. Make sure that wires are

not pinched between cover and box.