GE CSB9120SJSS Installationsanweisungen

NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4s. 

NOTE: Additional clearances between the cutouts 

may be required. Check to be sure the oven 

supports above the Warming Drawer location 

do not obstruct the required interior depth 

and height. See Warming Drawer installation 

instructions for details.

30s

23-1/2s

25-1/4s

Min.

21s

2

s

 Min. 

(3

s

 Recommended)

Per Warming 

Drawer 

Requirement

Construct Solid 

Bottom Min. 3/8s 

Plywood Supported 

by 2 x 4 or 2 x 2 

Runners all Four 

Sides

The Advantium 120V can be installed in 

combination with other GE/Monogram appliances. 

Always follow each product’s Installation 

Instructions to complete the installation.

Order a 30s wide single oven cabinet or cut 

the opening in a wall to the dimensions shown.

•  Allow 2-1/8s case trim overlap on the sides, 

1-1/16s overlap on the top and 7/8s overlap 

on the bottom of the opening for all models.  

•  Oven overlaps will conceal cut edges on all sides 

of the opening.

When installed over a single oven or a warming 

drawer, allow at least 2s between the two 

openings. This separation will provide clearance 

for bottom overlap of the Advantium 120V and the 

other appliance overlaps.
Construct a solid oven floor of 3/8s min. thick plywood 

supported by 2 x 4  or 2 x 2 runners on all sides.
•  The support must be level and rigidly mounted, 

flush with the bottom edge of the cutout.

30s

23-1/2s

25-1/4s

Min.

21s

Construct Base 

Min. 3/8s Plywood 

Supported by 2 x 

4 or 2 x 2 Runners 

all Four Sides

36-3/4s

Min.*

* Required  for 

Monogram models

* Required  for 

Monogram models

36-3/4s

Min.*