Monogram ZV1050SFSS Installationsanweisungen

• Pretap or drive decorative screw into the screw

 This will make screw

installation easier.

• Separate the two decorative duct covers.
• Select the inside cover (top), which has two screw

holes in the top.

• Slide the decorative duct cover over the support

frame and push to the ceiling.

• Attach to the hood support at the top with 2 supplied

decorative screws.

• Locate the 3rd decorative screw in the hardware

package. Set aside.

• Slide the lower decorative duct over the installed

upper duct and push to the top, keeping the bottom
slotted hole to the left.

• Install the decorative stop screw in center hole of

upper (inner) duct cover. The decorative screw will act
as a stop screw and prevent the lower decorative duct
cover from sliding down.

The stop screw must be installed.

Failure to do so could result in personal injury or damage
to the duct cover.

La vis supérieure doit être

en place, afin d’éviter les blessures ou d’endommager
le capot antipoussière.

• Lift the hood up to the support frame. Carefully align

the hood mounting holes to support frame holes, and
at the same time, the hood duct connector into the
duct.

• Install screws through the hood and hood support.
• Check hood level in both directions.
• Check to be sure that the duct is positioned over the

hood connector.

• Seal the duct connection with duct tape.

 Do not drive screws through this duct connection.

Doing so will prevent proper damper operation.

Stop Screw

Apply Duct Tape

to Seal Duct

Connection

Install

4 Lock Washers

and 4 Machine Bolts

Bottom

Duct

Cover

Pretap

2 Screw 

Holes

(One

On

Each

Side)

Top Duct

Cover

Install Screw on

Each Side

Bottom Duct Cover

Top Duct

Cover

Bottom Duct

Cover

Top Duct

Cover

Install Stop
Screw in Hole
of Upper (Inner) 
Duct Cover

Stop

Screw