Dacor ER36GSCHNGH Handbuch

17

IR (Infrared) Broil Burner

To prevent damage to the broil burner, do not spray the 

burner or its igniter with any type of cleaner or attempt to 

scrub them in any manner.

The IR broil burner is self-cleaning. To burn off any 

grime build-up, close the oven door and turn the 

oven control knob to the BROIL position for about 

ten minutes. After ten minutes turn the oven off.

Convection Filter (Oven)

The convection filter is made of stainless steel. 

•

Remove it only when it is cool.  
Re-install the filter before cooking in the oven again. 

•

Failure to do so will expose the convection fan blade 

that rotates at high speed during convection modes.

Convection Filter Removal and Cleaning

Remove the filter regularly for cleaning. A 

• 

clogged filter will reduce the effectiveness of 

convection cooking. Soak it in hot soapy water. 

Dry it completely before re-installing. 

To reinstall the filter, orient it so that the mount-

• 

ing clips are towards the rear of the oven cham-

ber, open end down. Hook the mounting clips 

over the horizontal bar across the opening.

Care and Cleaning

Replacing the Oven Light

Make certain that the oven and light bulb are cool and 

•

that power to the range has been disconnected before 

replacing the light bulb.
Always ensure that the lens cover is in place when 

•

using the oven. The lens cover protects the bulb from 

breakage and damage.

Replacing a Light Bulb

Light bulb replacement is considered to be a hom-

eowner maintenance operation. 
Your range has two halogen oven lights to enhance 

the view into the oven. The light assemblies consist 

of a removable lens cover and 20 Watt, 12 Vac halo-

gen bulb, as well as a light fixture housing.

To replace the bulb, disconnect the range power 

1. 

cord from the electrical outlet.
Remove the rack support in front of the fixture 

2. 

with the burned out bulb. See facing page.
Remove the lens cover from the housing by pull-

3. 

ing straight out. In some cases the lens cover 

may be tight enough to require the use of your 

lens pry stick. It comes packed with your range. 

Use the lens pry stick with caution. Do not cause 

uneven stress on the lens cover. Gently insert 

the pointed end of the pry stick under the center 

edge of the lens cover on the side facing the 

oven door. Hold your hand under the lens for 

support then pry out to remove.

Pull the light bulb out and replace it with a 

4. 

20-watt halogen bulb rated for use in an oven. 

Use Dacor Part No. 100429 available from any 

authorized Dacor parts distributor or at www.

everythingdacor.com.
Reinstall the lens cover by aligning the cover 

5. 

over the opening and gently pressing it into its 

original position. IMPORTANT: Be sure to line 

up the cutout in the lens with the light socket.
Replace the rack support and reconnect the 

6. 

power cord.

Clips on back 

of filter

Horizontal 

bar

Lens cutout

Light fixture

Light socket

Lens

Bulb

Lens pry stick