Summit SWC6GBLBISH Benutzerhandbuch

 

 

Felix Storch, Inc.  
SUMMIT PROFESSIONAL DIV.                                                                                                                                                                                 

Page 11  

Note:  The directions below are for installation under a cabinet in a 24 inch cutout space. If you will be using this product in a 
freestanding application, please skip below, and begin with step A1 in lower half of page.  

1.  Remove door from chassis by unscrewing 3 screws in top hinge and 

2 screws in bottom hinge. Keep screws, discard hinges.  

2.  Remove top and bottom hinge bushings.  

3.  Remove frame from door.  

4.  Attach customer-supplied handle to door panel using countersunk 

screws.  

5.  Screw door panel to frame using 14 screws.  

6.  Slide frame over refrigerator door and attach with 1 screw on each 

side on center of door.  

7.  Attach top brace to frame with 1 screw on each side. Attach bottom 

brace in the same manner.  

8.  Drill a hole through the top and bottom panel using the braces as a 

guide with a 1/8” drill bit. Install screws to finish attaching the top and 
bottom braces securely to the frame. 

9.  Drill a hole into the door panel from the top and bottom using the 

braces as a guide with 1/4” drill bit. Do not exceed 5/8” deep. This is 
the hole that the door will pivot on.  

10. Remount the door using the supplied top and bottom hinges.