Frigidaire FGGF3058RW Benutzeranleitung

Seite von 40
26
SETTING OVEN CONTROLS
Operating the oven light
The oven light will automatically turn ON when the oven 
door is opened.
Press 
 to turn the oven light ON and OFF whenever 
the oven door is closed.
The oven light is located at the upper left rear wall of the 
oven interior and is covered with a glass shield held by a 
wire holder. The glass shield must be in place whenever 
the oven is in use.
Your appliance has been factory calibrated and tested 
to ensure an accurate baking temperature. For the first 
few uses, follow your recipe times and temperature 
recommendations carefully. If you think the oven is 
cooking too hot or too cool for your recipe times, you can 
adjust the control so the oven cooks hotter or cooler than 
the temperature displayed.
The oven temperature may be increased +35°F (+19°C) 
or decreased -35°F (-19°C) from the factory settings.
Example: increase the oven temperature by 30°F:
Adjusting the oven temperature
Step 
Press
1.  Press and hold bake 
 
for 6 seconds.
2.  Enter 30. 
3.  To accept, press start. 
Example: decrease the oven temperature by 30°F:
Step 
Press
1.  Press and hold bake 
 
for 6 seconds.
2.  Enter 30. 
3. Press 
self clean
4.  To accept, press start. 
NOTES
Restoring to factory default settings
When new, your appliance was set with preset oven 
control settings. Over time, the user may make changes to 
these default settings.
The following features have user program options or 
adjustments that may have been modified from the factory 
default settings:
 12 or 24 hour clock display mode.
 6-Hour Engergy Savings or continuous bake mode.
 Silent or audible keypad operation.
 Oven temperature display mode (F° or C°).
 Any oven temperature offset adjustment made.
 Temp probe options (some models).
 Any stored favorite recipes (some models).
Before restoring the settings, be aware that all 
changes made to the oven control settings will be 
erased once the start keypad is pressed. This includes 
any temperature offset made for the oven.
1. Press 
and hold 7 keypad until 
 
acceptance tone sounds
 
(about 6 seconds).
2.  To accept, press start. 
Step 
Press
To restore oven control to factory settings:
 Oven temperature adjustments made will not affect 
the broil or self-clean operating temperatures.
 If the temperature shows an adjustment of -30°F, 
and a +30°F adjustment is needed, you can toggle 
between the (-) or (+) in the display by pressing self 
clean.
 Do not use oven thermometers such as those found 
in grocery stores to check the temperature settings 
inside your oven. These oven thermometers may 
vary as much as 20 to 40 degrees from actual 
temperatures.
NOTE
The oven light will not operate when self-clean is active. 
If the oven light is ON when setting self-clean, the oven 
light will turn off.
IMPORTANT