Frigidaire FGGF3058RW Benutzeranleitung

37

Oven portion of 

appliance does not 

operate. Gas cooktop 

burners operate.

Gas regulator shut-off valve 

may have been moved to OFF 

at installation.

Be sure gas regulator valve is set to the ON position. See 

installation instructions.

Incorrect oven control setting.

Be sure the oven control was set correctly for the requested 

feature. See Setting Oven Controls section and review 

instructions for the desired cooking function in this manual or 

see “Entire appliance does not operate” in this checklist.

Entire appliance does 

not operate.

Power supply to appliance 

disconnected or electrical 

power outage.

Be sure appliance power cord is plugged properly to electrical 

outlet. Check house circuit breaker; reset if needed. If the 

electric service to the house is out, call your local electric utility 

for service.

Service wiring is incomplete.

Contact your dealer, installing agent or authorized service 

agent for assistance.

Range is not level.

Floor is not level, weak or 

unstable.

If floor under range is sagging or sloping, contact a carpenter 

to correct the problem.

The cooktop or oven racks are 

not level.

To correct, place oven rack in center of oven. Place a bubble 

level centered on the oven rack. Adjust by turning leveling legs 

at bottom of range until the oven rack rests level.

Cabinet alignment may make 

range appear not level.

Be sure kitchen cabinets are square and have sufficient room 

for appliance clearance.

Cannot move 

appliance easily. 

Appliance must 

be accessible for 

service.

Gas line is hard-plumbed.

Replace gas supply line with a flexible CSA International 

approved metal appliance connector.

Carpet interferes with range.

Provide sufficient space so appliance may be lifted over carpet.

Cabinets are built in too tightly 

to appliance sides.

Contact builder or installer to make appliance accessible.

Convect fan makes 

noise (some models).

The convect fan may turn ON 

or OFF automatically.

This is normal. On some cooking features the convect fan may 

run until the feature is done or the oven door is opened.

Convect fan does not 

start immediately or 

turns ON and OFF 

while cooking (some 

models).

The convect fan start time is 

delayed.

This is normal. The convect fan will take 6 minutes to 

begin rotating after starting any convect feature.

Oven door is open.

The convect fan will turn OFF if the oven door is opened while 

any convect feature is active. Close oven door.

Convect fan turns on 

with features  that 

should run without a 

fan (some models).

The convect fan may turn ON 

while preheating.

This is normal (on some models).

Oven control displays 

“Prob ERR”. 

The probe is not 

recognized by the 

oven control.

The probe is not fully inserted 

into the probe receptacle.

Double check that the temp probe is fully inserted into probe 

receptacle. Use only the probe originally supplied with range.

If the error code persists, the 

probe may be damaged or the 

probe cable has a short.

Remove the probe from receptacle and oven. The oven may 

still be used normally without the probe. Call your authorized 

service agent.

Solutions to common problems

•