Frigidaire FGIS3065PF Installationsanweisungen

12

1.  Draw a center line (CL) on the floor where the range

should be installed. Also draw a line on the floor at

the range back position if there is no wall.

2.  Unfold paper template and place it flat on the floor

with the right rear corner positioned exactly on the 

intersection of the center and back lines you just 

drew before. (Use the diagram below to locate 

brackets if template is not available. (Figure 11))

3.  Mark on the floor (or wall) the location of the

mounting holes shown on the template. For easier 

installation, 3/16" (0,48 cm) diameter pilot holes 1/2" 

(1,27 cm) deep can be drilled into the floor (or wall).

4.  Remove template and place bracket on floor. Line up

holes in bracket with marks on floor/wall and attach

with screws provided. Bracket must be secured to 

solid floor or wall (Figure 12). If attaching to concrete

floor, first drill 3/16" (0,48 cm) dia. pilot holes using

masonry drill bit.

5.  Be sure the 4 levelling legs are at the highest 

position they can be.

6.  Slide range into place making sure structure of the 

range is trapped by the anti-tip bracket (Figure 14). 

Lower the range by adjusting the levelling legs until 

the underside of the cooktop is sitting level on the 

countertop. Refer to “Levelling the Range” section.

7.  After installation, verify that the anti-tip bracket is 

engaged by grasping the top rear edge of the range 

and carefully attempt to tilt it forward to make sure 

range is properly anchored.

 To reduce the risk of tipping of the 

range, the range must be secured to the floor by

properly installed anti-tip bracket and screws packed 

with the range. These parts are located in the oven. 

Failure to install the anti-tip bracket will allow the range 

to tip over if excessive weight is placed on an open door 

or if a child climbs upon it. Serious injury might result 

from spilled hot liquids or from the range itself.
Follow the instructions below to install the anti-tip 

brackets.
If range is ever moved to a different location, the anti-

tip brackets must also be moved and installed with the 

range.
Tools Required:

Adjustable Wrench

Ratchet

Drill & 1/8" (0,32 cm) bit

5/16" (0,8 cm) Nutdriver

Level

The anti-tip bracket attaches to the floor (or back wall)

at the back of the range to prevent range from tipping. 

When fastening bracket to the floor, be sure that screws

do not penetrate electrical wiring or plumbing. The 

screws provided will work in either wood or concrete.

Range

Anti-Tip Bracket

Floor Mount

Rear of Range

Wall

Mount