Maytag MVWC415EW Benutzung Und Pflege

 To allow for higher spin speeds, the lid will lock and the 

Lid Locked light will turn on. When this light is lit, the lid is 

locked and cannot be opened. When this light is blinking, 

the washer is paused. When this light is off, the lid can be 

opened. Washer lid lock will remain unlocked until first spin. 

After a cycle is started, water will enter washer. If you need to 

open the lid to add a garment after lid has locked, you must 

press START/Pause and wait for the lid to unlock. The lid will 

only unlock after washer movement has stopped. Depending 

on when in the cycle you try to pause, it may take several 

seconds to several minutes for the lid to unlock. Then add 

garment, close lid, and press START/Pause again to resume 

the cycle. 
NOTE: If the START/Pause button is held for more than  

3 seconds, the cycle will cancel and the washer will drain.

 

■

After the washer basket fills to the desired water level, the lid must be closed before the wash cycle can start. If filling stops with the lid 

open, close lid, and press START button. If lid is left open for more than 10 minutes, the water will pump out automatically. 

   This washer will perform a series of spins to check for  

load size and determine the correct water level for the  

load. During this time, a series of clicks and a whirring  

noise signal that sensing technology is determining if  

there is an off-balance load.

 At different stages of the wash cycle, you may hear sounds 

and pauses that are different from those of your previous 

washer. For example, you may hear a clicking and hum at the 

beginning of the cycle as the lid lock goes through a self-test. 

There will be different kinds of humming and whirring sounds 

as the agitator tests for load balance or moves the load. And, 

sometimes, you may hear nothing at all as the washer allows 

time for clothes to soak.

Your new washer will operate differently than your past agitator-style washer.