Whirlpool WEG760H0DE Dimensionale Illustrationen
Type of Gas
Natural gas:
This range is design-certified by CSA International for use with Natural gas or, after
proper conversion, for use with LP gas.
proper conversion, for use with LP gas.
●
This range is factory set for use with Natural gas. See “Gas Conversions” section.
The model/serial rating plate located behind the control panel has information on
the types of gas that can be used. If the types of gas listed do not include the type
of gas available, check with the local gas supplier.
The model/serial rating plate located behind the control panel has information on
the types of gas that can be used. If the types of gas listed do not include the type
of gas available, check with the local gas supplier.
LP gas conversion:
Conversion must be done by a qualified service technician.
No attempt shall be made to convert the appliance from the gas specified on the
model/serial rating plate for use with a different gas without consulting the serving
gas supplier. See “Gas Conversions” section.
No attempt shall be made to convert the appliance from the gas specified on the
model/serial rating plate for use with a different gas without consulting the serving
gas supplier. See “Gas Conversions” section.
†®
TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
30" (76.2 cm) Slide-in Gas Range
PRODUCT MODEL NUMBERS
PRODUCT DIMENSIONS
WEG730H
0
D
WEG760H
0
D
Gas supply line:
●
Provide a gas supply line of
³⁄₄" (1.9 cm) rigid pipe to the range
location. A smaller size pipe on longer runs may result in
insufficient gas supply. With LP gas, piping or tubing size can
be
insufficient gas supply. With LP gas, piping or tubing size can
be
¹⁄₂" (1.3 cm) minimum. Usually, LP gas suppliers determine
the size and materials used in the system.
NOTE:
Pipe-joint compounds that resist the action of LP gas
must be used. Do not use TEFLON
®†
tape.
Flexible metal appliance connector:
●
If local codes permit, a new CSA design-certified, 4 to 5 ft
(122 to 152.4 cm) long,
(122 to 152.4 cm) long,
¹⁄₂" (1.3 cm) or ³⁄₄" (1.9 cm) I.D.,
flexible metal appliance connector may be used for connecting
range to the gas supply line.
range to the gas supply line.
●
A
¹⁄₂" (1.3 cm) male pipe thread is needed for connection to
the female pipe threads of the inlet to the appliance pressure
regulator.
regulator.
●
Do not kink or damage the flexible metal tubing when moving
the range.
the range.
●
Must include a shutoff valve:
The supply line must be equipped with a manual shutoff valve.
This valve should be located in the same room but external to
the range opening, such as an adjacent cabinet. It should be in a
location that allows ease of opening and closing. Do not block
access to shutoff valve. The valve is for turning on or shutting
off gas to the range.
The supply line must be equipped with a manual shutoff valve.
This valve should be located in the same room but external to
the range opening, such as an adjacent cabinet. It should be in a
location that allows ease of opening and closing. Do not block
access to shutoff valve. The valve is for turning on or shutting
off gas to the range.
Gas Pressure Regulator
The gas pressure regulator supplied with this range must be
used. The inlet pressure to the regulator should be as follows for
proper operation:
used. The inlet pressure to the regulator should be as follows for
proper operation:
Natural gas:
Minimum pressure: 5" WCP
Maximum pressure: 14" WCP
Minimum pressure: 5" WCP
Maximum pressure: 14" WCP
LP gas:
Minimum pressure: 11" WCP
Maximum pressure: 14" WCP
Contact local gas supplier if you are not sure about the inlet
pressure.
Minimum pressure: 11" WCP
Maximum pressure: 14" WCP
Contact local gas supplier if you are not sure about the inlet
pressure.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Instructions packed with product. Specifications subject to change without notice.
Ref. W10665256B
9/14
A. 1
³⁄₁₆
" (3.0 cm) height from
cooktop to top of vent
B. 29
⁷⁄₈
" (75.9 cm)
C. Model/serial number plate
(located behind the oven door on
the top right-hand side of the
oven frame)
the top right-hand side of the
oven frame)
D. 36" (91.4 cm) height to top of
cooktop edge with leveling legs
screwed all the way in*
screwed all the way in*
E. 28
⁵⁄₁₆
" (71.9 cm) max.
depth from front of console
to back of range.
to back of range.
F. 28
⁷⁄₈
" (73.3 cm) max. depth
from handle to back of
range.
range.
B
D
A
F
E
C
A. Gas supply line
B. Shutoff valve “open” position
B. Shutoff valve “open” position
C. To range
A
B
C
Page 1 of 2
GAS SUPPLY REQUIREMENTS
This manual covers several models. Your model may appear different from the
models depicted. Dimensions given are maximum dimensions across all models.
models depicted. Dimensions given are maximum dimensions across all models.
IMPORTANT:
Range must be level after installation. Follow the instructions in the
“Level Range” section. Using the cooktop as a reference for leveling the range is not
recommended.
recommended.
*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.