Dacor SGM365SLP Betriebsanweisung
22
6. Do not use water on grease fires. A violent
steam explosion may result. Smother any
flames with a lid, cookie sheet or flat tray.
Flaming grease can be extinguished with
baking soda or a multi-purpose chemical or
foam extinguisher.
7. Do not allow potholders to touch gas
burners. Do not use a towel or bulky cloth
as a potholder.
8. Do not block or obstruct the holes beneath
the control knobs. Blocking these holes
may affect burner operation and may result
in a hazard.
9. When using the cooktop, do not touch the
grates, burner caps, burner bases, or any
other parts in proximity to the flame. These
components may be hot enough to cause
burns.
10. If the cooktop is near a window, do not use
long curtains as a window treatment. They
can blow over the cooktop and create a fire
hazard.
11. Do not cover the burners and grates with
anything except properly selected utensils.
Decorative covers should not be used.
12. Do not heat unopened food containers
such as baby food jars and cans. Pressure
build-up may cause the container to burst
and cause injury.
13. Do not use abrasive or caustic cleaners
or detergents on this appliance, as these
may cause permanent damage. Do not
use aerosol cleaners, as these may be
flammable or cause corrosion of metal
parts.
14. Do not use or attempt to use this appliance
in the event of a power failure.
Sealed Burners
On SGM304 and SGM364 Cooktops, there are
a total of four burners, including one burner
rated at a maximum output of 14,000 BTU/HR,
one burner rated at a maximum of 12,500 BTU/
HR and two burners rated at a maximum output
of 8,500 BTU/HR. The knobs are grouped in
twos. The front two knobs operate the front two
burners, and the rear two knobs control the two
rear burners.
8,500 BTU
14,000 BTU
8,500 BTU
12,500 BTU
SGM304
Top View
On the SGM365 Cooktop, there are a total
of five burners, including one burner rated at
a maximum output of 14,000 BTU/HR, two
burners rated at a maximum of 12,500 BTU/HR
and two burners rated at a maximum output of
8,500 BTU/HR. The knobs are positioned to
correspond with the burner layout.
8,500 BTU
14,000 BTU
8,500 BTU
12,500 BTU
12,500 BTU
SGM365
Top View
On the SGM466 Cooktop, there are a total
of six burners, including two burners rated at
a maximum output of 14,000 BTU/HR, one
burner rated at a maximum of 12,500 BTU/HR
and three burners rated at a maximum output
of 8,500 BTU/HR. The knobs are grouped in
threes. The front three knobs operate the front
three burners, and the rear three knobs control
the three rear burners.
8,500 BTU
14,000 BTU
14,000 BTU
8,500 BTU
12,500 BTU
8,500 BTU
SGM466
Top View
On the SGM464GG Cooktop, there are a total
of five burners, including one burner rated at a
maximum output of 14,000 BTU/HR, one burner
rated at a maximum of 12,500 BTU/HR, two
burners rated at a maximum output of 8,500
BTU/HR and one burner rated at a maximum of
9,300 BTU/HR (gas grill burner). The front two
knobs operate the front two burners, and the
center knob controls the gas grill.
8,500 BTU
Gas
Grill
Knob
12,500 BTU
8,500 BTU
14,000 BTU
SGM464GG
Top View
Brass Burner Rings
All burners are attached to the cooktop by
retaining nuts. Gaskets around the undersides
of the burner bases ensure that the burners are
sealed, thereby preventing any liquid spills from
entering the cooktop chassis. All spills remain
on the surface of the cooktop.
The brass burner rings spread the flame evenly
around the burner perimeters. The burner rings
must seat properly in the burner bases to enable
proper cooktop operation. To ensure proper
seating, positioning tabs have been placed
on the bottom of each burner ring to slide into
corresponding notches in the fixed burner base.
SGM Burner Assembly
Smart-Flame
Each burner ring features Smart-Flame. When
oriented properly by the burner ring positioning
tabs, Smart-Flame prevents direct flame
impingement on the fingers of the porcelain
grate. This reduces temperatures on the
grate and improves flame and performance
characteristics, as well as increasing longevity of
the porcelain enamel coating on the grate.
Burner Ignitors and Perma Flame
A burner igniter is located on each gas burner
base. When a control knob is rotated more than
90˚ counterclockwise, on the SGM models,
all ignitors will spark simultaneously, but only
the selected burner will ignite. Additionally,
due to the Perma-Flame reignition feature,
the ignitors will spark automatically if a flame
should blow out or be severely distorted by a
draft or by a cooktop ventilation system. Burner
ignitors must always be kept clean and dry to
function properly. Dirty or wet ignitors will result
in constant sparking, even if there is a flame
present.
Smart-Flame Burner Ring Notches