Dacor DR30GFSNGH Designanleitung

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

™

Document # PG05-007

Revised 04/04/13   Page 1/5

•  Observe all governing codes and ordinances during planning 

and installation. Contact your local building department for 

further information. 

•  This appliance must be installed in accordance with the 

accompanying installation instructions.

All tolerances ±1/16” (±1.6 mm) unless otherwise noted.

 AER30GLBG

Low profile (1 3/4 inch)

Standard on models DR30GIS, DR30GIFS

Optional on models DR30GS, DR30GFS

AERB30G03

3 Inch

Optional on models DR30GS, DR30GFS

NOT compatible with models DR30GIS, DR30GIFS

AERB30G06

6 Inch

Standard on models DR30GS, DR30GFS

NOT compatible with models DR30GIS, DR30GIFS

AERB30G09

9 Inch

Optional on models DR30GS, DR30GFS

NOT compatible with models DR30GIS, DR30GIFS

1 1/8” (2.9 cm)

DR30GI[F]S:

1/4” (6.4 mm)

thick top trim

Front of open door
Front of handle

Front panel

Rear of front panel

Backguard thickness

26 1/8” (66.4 cm)

28 9/16” (72.5 cm)

Front of knobs

28” (71.1 cm)

24” (61.0 cm)

3” (7.6 cm)

backguard*

DR30G[F]S:

Full stainless

steel side panels

DR30GI[F]S:

3 1/2” (8.9 cm)

partial stainless

steel side panels

(removable)

External handle

shown, some models

have integral handle

(see inside cover)

Grates extend

1” above trim

6” (15.2 cm)

backguard*

1 3/4” (4.4 cm) backguard*

* See table for compatibility

Product width:

29 7/8” (75.9 cm)

NOTE: Models DR30GS and

DR30GFS are not compatible

with a raised vent.

35”

(88.9 cm)

to

37”

(94.0 cm)

9” (22.9 cm)

Backguard*

46 3/4” (118.7 cm)

2

1

1 Only backguard model AER30GLBG is compatible with a raised vent.

1