COYOTE CPB Handbuch
17
gap between the electrode and contact point.
•
Check for a loose wire connection at the electrode box.
•
Check to see if debris is blocking the electrodes.
•
If the igniter is not working, can you light the power burner with
a lighter?
Flare-ups
•
Check frame body and cooking grate for excess food or
grease build-up.
•
Ensure power burner is not placed directly in the path of wind.
•
Be sure drip tray is clean
Note: Some flare-ups may be inevitable if cooking greasy
foods.
Yellow Flames
•
Check the burner inlet for obstructions, particularly at air inlets
for each burner.
for each burner.
•
Power burner may be in an area that is too windy.
•
Ensure correct gas supply is being used with correct appliance
type (LP / NG)
type (LP / NG)
Flame blows out on low setting
or has uneven heat distribution.
•
Check for spider webs or insect nest in venturi and clean
venturi.
venturi.
•
Venturi may be misaligned and needs to be lined up over
orifices.
orifices.
•
Windy weather will require you to move power burner away
from the wind.
from the wind.
•
Lack of fuel. Check to see cylinder valve is open and cylinder
has fuel.
has fuel.
Low heat with the knob on
“HIGH”
•
Check to see if the fuel hose is bent or kinked.
•
Make sure the power burner area is clear of dust.
•
Check your gas supply and gas pressure.
•
If it is only one burner that appears low, make sure the orifice
or burner is clean.
or burner is clean.
Power burner is Too Hot
•
Excess grease build-up causing grease fires.
•
Damaged or faulty regulator.
•
Replace with factory authorized parts.
•
Cook on a lower temperature setting.
Flame behind control panel or
control knob area.
IMMEDIATELY shut off cylinder valve and allow power burner
to cool.
•
C
heck for spider webs or insect nest in venturi and clean
venturi.
•
Gas is leaking from a faulty connection. Tighten connections
with an adjustable wrench and replace damaged parts.
Perform a leak test on all connections before cooking on
power burner again.
with an adjustable wrench and replace damaged parts.
Perform a leak test on all connections before cooking on
power burner again.
•
Venturi may be misaligned and needs to be lined up over
orifice.
orifice.
Fire at any connection.
IMMEDIATELY shut off cylinder valve and allow power burner
to cool.
•
Gas is leaking from a faulty connection. Tighten connections
with an adjustable wrench and replace damaged parts.
with an adjustable wrench and replace damaged parts.
•
Perform a leak test on all connections before cooking on
power burner again.
power burner again.