Dacor DR30GFSLPH Handbuch

6

Cooktop Assembly

The burner rings spread the flame evenly around 

the burner cap. All burner parts must be properly 

seated for proper burner lighting and operation.

1.  Remove the burner rings, burner caps and 

grates from their shipping packages.

2.  Install the burners as shown below. Gently twist 

each piece back and forth after installation to 

make sure it is properly seated. A small gap 

below the burner ring is normal when installed 

properly.

3.  Gently set the grates on top of the spill tray. Put 

the legs of each grate inside the corresponding 

dimples.

Setting Up Your Range

(left front burner only)

(left rear, right front, right rear burners)

STEP 1: Install 

SimmerSear burner 

ring on SimmerSear 

burner base. Line 

up indentations on 

bottom of burner ring 

with pins on top of 

burner base.

STEP 1: Install 

standard burner 

rings on standard 

burner bases. Put 

holes on edge of 

each ring over 

the igniter. Center 

tabs on bottom of 

each ring in hole 

in center of each 

base.

STEP 2: Set outer 

SimmerSear burner 

cap on SimmerSear 

burner ring. Make sure 

it is centered on top.

STEP 2: Install all 

standard burner 

caps. Ridge on 

bottom of caps 

must surround 

top of ring.

STEP 3: Set inner 

SimmerSear burner 

cap on center of 

SimmerSear burner 

base. Line up ridge 

on bottom of cap 

with pins on center of 

burner base.

Inner burner cap

Ridge on bottom

Ridge on bottom 

of burner cap

Outer burner cap

Burner ring

Pin on burner base

Igniter on burner base

Burner ring - 

top view

Igniter hole