Dacor DR30GFSLPH Installationsanweisungen

Installation Instructions

Moving the Range to Final Location

1.  Peel the protective plastic coating off of the range, 

including the range door.

2.  Uncoil the power cord and route it to the electrical 

outlet so that it does not become trapped behind 

the range when it is pushed back. Do not connect 

the power plug until you are ready to verify proper 

operation.

3.  Carefully slide the range into position. Be careful not 

to kink the power cord or gas line as you push the unit 

back. The rear leg should engage the anti-tip bracket 

as you slide it back. 

4.  Using a flashlight look underneath the range and verify 

that the anti-tip bracket covers the rear leg.

Re-Installing the Door

To avoid personal injury or damage to the door from it 

falling off its hinges:
•  Make sure that the notch on the bottom of each hinge 

rests on top of the lower lip of each hinge receptacle 

before attempting to open the oven door.

•  Rotate the hinge locks toward the front of the range 

immediately after installation of the door.

1.  Grasp the oven door on opposite sides and hold it at a 

15° angle from the front of the oven. Slide the hinges 

into the hinge openings, resting the bottom of the hinge 

arms on the hinge receptacles. 

2.  Continue to hold the door at a 15° angle with one hand 

while pushing in on each of the bottom corners of the 

door. Push until the notch on the bottom of each hinge 

slips over the lower lip of each hinge receptacle.

3.  Lower the door to the fully opened position.
4.  Rotate the two hinge catches toward the oven. Slowly 

and carefully open and close the door completely to 

ensure that it is properly installed.

5.  Remove any packaging from inside the oven.

Lower lip of hinge 

receptacle

Notch

Anti-tip 

bracket

Rear leg