Dacor ERV3015 Installationsanweisungen

Installation Instructions

Verifying Proper Operation

•  Read the raised vent use and care manual completely 

before operation.

•  Install all of the front filters prior to operating the raised 

vent. Refer to the use and care manual for filter instal-

lation instructions.

To prevent damage to the raised vent power cord, route 

it away from the surfaces of the cooking appliance before 

connecting it.

1.  Make sure the power switch on the top of the raised 

vent is in the up position.

2.  Plug the raised vent power plug into the electrical out-

let.

3.  Press the power switch once to raise the vent to its 

operating position.

4.  Once in the up position the vent should begin to draw 

air. Turn the variable speed control switch in both direc-

tions to verify that the system is operating correctly.

5.  Press the top cap up/down switch once to lower the 

vent.

6.  Make sure that the top cap on the raised vent intake 

does not catch on the back edge of the cooking appli-

ance when the intake is lowered. If interference occurs, 

adjust the position of the cooking appliance. Failure 

to eliminate any interference may result in permanent 

damage to the vent.

If the raised vent is not operational after installation:
•  Make sure that power is being supplied to the unit.
•  Make sure that power is being supplied to the blower 

from the raised vent.

•  If the vent will not raise properly or makes a scraping 

sound check for obstructions interfering with the raising 

of the unit.

If the raised vent still does not function after performing the 

above checks, do not attempt to repair it yourself. Contact 

Dacor Distinctive Service at (877) 337-3226. Be sure to 

have all model and serial numbers from the product data 

labels for the raised vent and the blower available when 

you call.
Dacor is not responsible for the cost of correcting problems 

caused by a faulty installation.

Installation Checklist

 

□

Are the anchor legs extended down to make contact 

with the floor and tightened into place? Are the anchor 

legs fastened to the floor? Is the unit level? 

 

□

Is the duct work completely installed? Are all joints 

attached with sheet metal screws and wrapped with 

duct tape?

 

□

Are both ends of the remote or in-line blower power 

cable connected (to the raised vent and to the blower 

itself?)

 

□

Are the vent filters installed according to the use and 

care manual instructions?

 

□

Is the power cord routed away from the hot surfaces of 

the cooking appliance.

 

□

Is the unit connected to an electrical outlet that meets 

the electrical specifications in these instructions?

 

□

Has proper operation been verified?

 

□

Has the warranty been activated on-line or the warranty 

card been filled out completely and mailed?