Faber INHC29SS Spezifikationenblatt
6” round
duct
Side View
Cut-Out
Bottom View
Note: The Inca HC comes
standard in the top vent
position. The direct rear vent
position can be achieved by
rotating the blower housing.
standard in the top vent
position. The direct rear vent
position can be achieved by
rotating the blower housing.
Dimensional Diagrams
Rev. 07/11
WARNING
!
Product specifications are subject to change without notification. Consult the installation instructions
before you begin installing this rangehood.
Make your ductrun as straight and
short as possible. The ductrun should
not exceed 35 equivalent feet if
ducted with the required minimum of
6” round duct. Count 45º angles as 3
feet, 90º elbows as 5 feet, and 90º flat
elbows as 12 feet.
For best results, use no more than
three 90° elbows. Make sure that
there is a minimum of 24” of straight
duct between elbows if more than
one is used. Do not install two
elbows together. If you must elbow
right away, do it as far away from
the hood’s exhaust opening as pos-
sible.
For more efficient airflow when
venting to the rear: Rotate the Inca
HC blower housing so that the 6”
round exhaust outlet faces the back,
rather than running ductwork up
and elbowing back.
Pre-Planning Your Ductwork
-
Important: Consult the installation instructions before you begin installing this rangehood.
Recirculating Installations
Front View
For installations where ductwork to the outside of your home is impossible or highly impractical
Charcoal Filters, which attach to the blower assembly, absorb smoke and odors.
cabinet
ceiling
hood
cabinet
ceiling
soffit
vent grate
vent grate
Some ductwork must
be installed to exhaust
the rangehood back into
the kitchen, either at the
top of the cabinet or at
the face of the soffit. A
plastic vent grate sup-
plied with the rangehood
can be used to cover the
duct opening. This duct
work must not terminate
into a dead air space.
6” round
duct
Liners
Standard Liner 36 Stainless (LINE36ST)
designed for 36” wide installations
designed for 36” wide installations
Standard Liner 30 Stainless (LINE30ST)
designed for 30” wide installations
designed for 30” wide installations
Create a perfectly-sealed, non-combustible perimeter around the Inca HC SS. Designed for 30” and 36” wide installations. Depth adjustable from 16” - 17 7/8”.
hood
Pre-Planning Your Installation
-
Important: Consult the installation instructions before you begin installing
this rangehood. The recommended height to install this hood off the cooktop is a minimum of 24” and a maximum
of 30” for maximum effectiveness. Also consult the cooktop manufacturer’s recommendation.
of 30” for maximum effectiveness. Also consult the cooktop manufacturer’s recommendation.