GE GEFLSTACK Installationsanweisungen

INSTALL DRYER AND BRACKET
ON WASHER

Lift the dryer on top of the washer.
Be careful not to scratch the top of the
washer with the brackets. Protect the
washer control panel with cardboard or
other protection. Be sure to lift the dryer
high enough to clear the washer control
panel.

WARNING

Potential Personal Injury. More than two
people are recommended to lift the dryer
into position because of its weight and size.
Failure to do so could result in personal
injury or death.

Align the holes in the bracket with the
holes in the back of the washer. Using a
Phillips screwdriver attach the 2 #8 x 1/2”
tapping screws. Repeat on both sides of
the washer.

Installation Instructions

INSTALL BRACKET TO DRYER

Align the holes in the left bracket with
the holes in the bottom left corner of the
dryer. Use a Phillips screwdriver to install
the 2 #12 x 1” tapping screws.

Repeat the above step with the right
bracket on the bottom right corner of the
dryer.

Set the dryer upright.

NOTE: Make sure to set the dryer on a piece
of packing material so the brackets that are
attached to the bottom of the dryer do not
damage the floor.

PREPARE THE WASHER
AND DRYER

Place the washer in the approximate
location.

Make sure the washer is level. Refer to
washer Installation Instructions for
details.

Remove the back portion of the control
panel by removing the 3 screws.

Reverse dryer door swing if desired. See
dryer installation instructions for details.

NOTE: The washer door swing is not
reversible.