Broan AP136SS Installationsanleitung

For performance, appearance, and health reasons, clean filter, 

fan and grease-laden surfaces. Use

only a clean cloth and mild

detergent solution on stainless and painted surfaces. Clean all-

metal filters in the dishwasher.

The motor is permanently lubricated and never needs oiling. If

the motor bearings make excessive or unusual noise, replace 

the motor with the exact service motor. The impeller should also 

be replaced.

Use 120 V, 50 W, shielded halogen bulbs - MR16 or PAR16 with

GU10 base. Purchase bulbs separately.

The grease filters, bottom panel, and blower wheel should be 

cleaned frequently. Use a warm detergent solution. The grease

filters and blower wheel are dishwasher safe.

Note: Some minerals, when in contact with dishwasher 

soap additives, may cause filters to discolor. This discol-

oration is not covered by the warranty.

SOFFIT

18" - 24" ABOVE

COOKING SURFACE

CABINET

3¼" X 10" DUCT

(For horizontal discharge)

WALL CAP

ROOF CAP

3¼" X 10" or

7" ROUND DUCT

(For vertical

discharge)

HOUSE WIRING

(Top or Back of hood)

HOOD

HOOD

1 

Determine whether hood will discharge vertically (3¼” x 

10” or 7” Round), or horizontally (3¼” x 10” only). For ver-

tical or horizontal discharge, run ductwork between the 

hood location and a roof cap or wall cap. For best results,

use a minimum number of transitions and elbows.

Always turn the hood ON before cooking in order to establish an

air flow in the kitchen. After turning off the range, let the hood run 

for a few minutes to clear the air.

Heat SentRY™
The hood is equipped with a Heat Sentry™ thermostat. This safety

device will turn on or speed up the blower if it senses excess heat 

above the cooking surface.
If the blower is not on, or if it is running at low speed, the Heat

Senttry™ will override the normal blower control and trun the

blower on the high speed. When the temperature level drops to

normal levels, the blower will return to its original setting.

Operate the hood as follows:

This 3-position switch turns blower ON and OFF and controls

blower speed.

Set switch to (1) position to turn blower ON to low speed.

Set switch to (2) position to turn blower ON to high speed.

Set switch to (0) position to turn blower OFF.

This  3-position  switch  turns  lights  ON  and  OFF  and  controls

their intensity.

Set switch to (1) position to turn lights ON to low intensity.

Set switch to (2) position to turn lights ON to high intensity.

Set switch to (0) position to turn lights OFF.

Operate the hood as follows:

Fan
The 2-position switch (in center) turns blower ON and OFF.
The 5-position switch (at left) controls blower speed.

Blower is OFF (secondary blower OFF).
Blower is ON at highest speed.

    As dots get smaller - blower speed decreases.

LigHt
This 3-position switch (at right) turns lights ON and OFF and

controls their intensity.

Lights are OFF.
Lights are ON to low intensity.
Lights are ON to highest intensity.

LIGHT

FAN

ON

OFF