Waste King H520 Installationsanweisungen

Remove faucet cap to access phillips head mounting screw. Refer to the appropriate drawing at
right for cap removal. Keep screw installed through the faucet as it will be used later in the
installation.

Remove masking tape and tag from water faucet. Lay faucet on flat surface with the coiled tubing
facing up. With one hand holding the tubes just below the spout, carefully straighten the tubes with
other hand. Slide gasket over tubes so that lip side of gasket is seated into base of faucet.

Loosen the square nut until it is flush with the end of the mounting screw. Tip the faucet bracket
against the mounting screw. (Bracket will form a “y” when in the correct position.)

Hold the nut, bracket, gasket and tubing in position and insert into hole in sink or counter. 

Pull up on the spout body to keep tension on the spout mounting bracket and nut. Tighten the
screw until the faucet is securely in position. 

To replace faucet cap, match flat areas of cap and faucet male/female connection.

Reassemble loop handle and tighten set screw in place using allen wrench provided. Place red plug
button, from accessory bag, in front hole of handle. 

Refer to tank installation instructions and illustration above to connect the Red line from the faucet
to the rear corner inlet tube on top of the tank.

Connect Blue line to cold water supply. Refer to tank instructions for connecting to water supply line.

WARRANTY: Quick&Hot Faucets are warranted for 1 year from the date of purchase.

Go to amckitchen.com or call (800) 854-3229 for further details.

On/Off
Cap

Carefully pull cap off the faucet
assembly and set cap to one
side.

Allen
screw

Using allen wrench provided,
loosen set screw inside hole
and remove lever handle from
faucet.

On/Off
Cap

gasket

mounting

screw

square nut

bracket

faucet