Dacor ER30GSCH Installationsanweisungen
8
Installation Instructions
Gas Connection
WARNING
Make sure the gas is turned off at the gas supply
•
valve before connecting the gas line.
Verify that the gas supply meets specifications before
Verify that the gas supply meets specifications before
•
connection. See page 4.
Do not apply excessive pressure when tightening gas
Do not apply excessive pressure when tightening gas
•
connections and fittings.
Do not use Teflon tape or plumber’s putty on flexible
Do not use Teflon tape or plumber’s putty on flexible
•
gas line connections.
Test the gas lines for leaks as instructed before use.
Test the gas lines for leaks as instructed before use.
•
If a leak is detected, open all doors and windows and
allow the gas to dissipate before fixing the leak and
testing the unit.
Do not use a flame to check for leaks.
Do not use a flame to check for leaks.
•
The maximum gas supply pressure to the regulator
•
must never exceed ½ pounds per square inch (psi) or
3.5 kPa.
The range and shut-off valve must be disconnected
The range and shut-off valve must be disconnected
•
from the gas supply piping system during any
pressure testing exceeding ½ psi (3.5 kPa).
The range must be isolated from the gas supply piping
The range must be isolated from the gas supply piping
•
system by closing the shut-off valve to the cooktop
during any gas supply piping system pressure testing
equal to or less than ½ psi (3.5 kPa).
For LP gas installations, the LP gas tank must have its
For LP gas installations, the LP gas tank must have its
•
own high-pressure regulator in addition to the pressure
regulator installed on the range.
IMPORTANT: The installed gas pressure regulator is pre-
set at the factory for the type of gas intended for use with
the appliance. Verify that the appliance is compatible with
the type of gas available by checking the product data label
attached to the appliance. Ranges intended for use with
LP gases will have “LP” as a part of the model number.
Consult your dealer if the range is not compatible with your
gas supply.
Make sure the gas supply valve is in the off position and
1.
range power cord is disconnected.
Connect a flexible gas supply line to the gas shut-off
Connect a flexible gas supply line to the gas shut-off
2.
valve previously installed on the stub out. The gas line
needs to be long enough to allow the range to be pulled
out for service.
Connect the gas line to the regulator on the back of the
Connect the gas line to the regulator on the back of the
3.
range.
Turn all cooktop control valves to the
Turn all cooktop control valves to the
4.
“OFF” position.
Turn on the gas supply valve and check
Turn on the gas supply valve and check
5.
all lines and connections for leaks using a
soap and water solution or an electronic
gas leak detector.
Turn the gas supply off.
Turn the gas supply off.
6.
Gas Line Connection
“OFF”
symbol on
knob
Anti-tip foot
1/16” off floor
1/2” male NPT
connection