Whirlpool WEG730H0DB Installationsanleitung

6. Place the broil burner on the broil burner orifice hood. Insert 

the broil burner ceramic igniter in the hole in the rear of the 
oven.

7. Replace the flame spreader with all 4 tabs facing up and the 

notches toward the rear of the oven.

8. Position the broil burner against the top of the oven and 

attach it with 1 screw.

9. Replace premium storage drawer, warming drawer or baking 

drawer. See the “Remove/Replace Drawer” section.

10. Replace the oven door. See the “Oven Door” section.

11. Replace the oven racks.

1. Refer to the “Make Gas Connection” section for proper 

connection of the range to the gas supply.

2. Refer to the “Electronic Ignition System” section for proper 

burner ignition and operation.

3. Refer to the “Adjust Flame Height” section for burner flame 

adjustments.

IMPORTANT: You may have to adjust the low setting for each 
cooktop burner.

Checking for proper cooktop flame is very important. The 
small inner cone should have a very distinct blue flame ¼" to 
½" (0.64 to 1.3 cm) long. The outer cone is not as distinct as 
the inner cone. LP gas flames have a slightly yellow tip.

4. Refer to “Complete Installation” in the “Installation 

Instructions” section of this manual to complete this 
procedure.

1. Turn the manual shutoff valve to the closed position.

2. Unplug range or disconnect power.

1. Remove the premium storage drawer, warming drawer or 

baking drawer. See the “Remove/Replace Drawer” section.

2. Locate gas pressure regulator at rear of the drawer 

compartment.

NOTE: On models with a warming drawer or baking drawer, 
an access cover must be removed to access the gas 
pressure regulator.

IMPORTANT: Do not remove the gas pressure regulator.

3. Remove plastic cover from gas pressure regulator cap.

IMPORTANT: Make sure to save the orifices that have 
just been replaced in the conversion.

A

B

C

A