Whirlpool WEG730H0DB Installationsanleitung

9. Replace the premium storage drawer, warming drawer or 

baking drawer. See the “Remove/Replace Drawer” section.

10. Replace the oven door. See the “Oven Door” section.

11. Replace the oven racks.

1. Refer to the “Make Gas Connection” section for proper 

connection of the range to the gas supply.

2. Refer to the “Electronic Ignition System” section for proper 

burner ignition and operation.

3. Refer to the “Adjust Flame Height” section for burner flame 

adjustments.

IMPORTANT: You may have to adjust the low setting for each 
cooktop burner.

Checking for proper cooktop, bake and broil burner flame is 
very important. Natural gas flames do not have yellow tips.

4. Refer to “Complete Installation” in the “Installation 

Instructions” section of this manual to complete this 
procedure.

Adjust the height of top burner flames. The cooktop “low” burner 
flame should be a steady blue flame approximately ¼" (0.64 cm) 
high. LP gas flames have a slightly yellow tip.

The flame can be adjusted using the adjustment screw in the 
center of the valve stem. The valve stem is located directly 
underneath the control knob.

1. Light 1 burner and turn to lowest setting.

2. Remove the control knob.

Hold the knob stem with a pair of pliers. Use a small flat-
blade screwdriver to turn the screw located in the center of 
the control knob stem until the flame is the proper size. 
Turning the screw clockwise will increase the flame size, and 
turning the screw counterclockwise will decrease the flame 
size.

3. Replace the control knob.

4. Test the flame by turning the control from the low position to 

the high position, checking the flame at each setting.

5. Repeat the previous steps for each burner.

1. Light burner and turn to lowest setting where both inner and 

outer burners are lit.

2. Remove the control knob.

3. Insert a 

¹⁄₈" (3 mm) flat-blade screwdriver into the adjustment 

locations shown in the following illustration and engage the 
slotted screw. Turn the screw until the flame is the proper 
size. Turning the screw clockwise will increase the flame size, 
and turning the screw counterclockwise will decrease the 
flame size.

4. Replace the control knob.

5. Test the flame by turning the control from the low position to 

the high position, checking the flame at each setting.

Refer to the User Guide for proper operation of the oven controls. 

IMPORTANT: Make sure to save the orifices that have 
just been replaced in the conversion.

A

B

A

B

C

A

B

C