BlueStar RGTNB24FTV2 Handbuch
10
ELECTRICAL CONNECTION
There is no connection necessary beyond
plugging the unit into a polarized, grounded,
120-volt, 60-Hz, 15-amp circuit. This circuit,
however, MUST be grounded and properly
polarized. This unit is not to be used with a
GFI.
120-volt, 60-Hz, 15-amp circuit. This circuit,
however, MUST be grounded and properly
polarized. This unit is not to be used with a
GFI.
The unit is equipped with a NEMA #5-15P
power cord, accessed by removing the rear
panel, and if an extension is required, it must
be at least this gauge.
panel, and if an extension is required, it must
be at least this gauge.
NOTE:
If electrical power is not supplied or is
interrupted, the unit will not be operational.
interrupted, the unit will not be operational.
WARNING ! ! !
This appliance is equipped with a three-pronged grounded plug for your protection against shock hazard and
should be plugged directly into a properly grounded receptacle.
Do not cut or remove the grounding prong from this plug.
If the unit is not grounded or its polarity is reversed, severe shock hazards can exist.
**Removing the third prong will void the manufacturers warranty**
INSTALLERS & END-USERS INITIAL CHECK
All units are adjusted and tested before leaving
the factory. The manufacturer has supplied you
with an installation checklist in order for your
technician to properly install your new unit.
Your unit must be installed to factory
specifications. Failure to perform the installation
checklist and returning it will void the warranty
the factory. The manufacturer has supplied you
with an installation checklist in order for your
technician to properly install your new unit.
Your unit must be installed to factory
specifications. Failure to perform the installation
checklist and returning it will void the warranty
coverage agreement. When the range is properly
installed and connected to proper gas and
electrical service, it will operate properly. Any
issues regarding service should be directed to
your distributor/dealer.
installed and connected to proper gas and
electrical service, it will operate properly. Any
issues regarding service should be directed to
your distributor/dealer.
FINAL PREPARATION FOR USE
New units are wiped clean at the factory to
remove any visible signs of dirt, oil, grease, etc.,
remaining from the manufacturing process, then
coated with a thin film of mineral oil. Some
stainless steel parts may have a protective plastic
wrapper, which must be peeled off. Prior to use,
the unit should be washed thoroughly with hot,
soapy water to remove these film residues and any
installation dust or debris, then rinsed and wiped
dry. Solutions stronger than soap and water are
rarely required.
soapy water to remove these film residues and any
installation dust or debris, then rinsed and wiped
dry. Solutions stronger than soap and water are
rarely required.