Summit SWC532LBIST Benutzerhandbuch
9
the internal cabinet temperature. The SET temperature is automatically saved.
Upper chamber: Temperature setting can be adjusted from 41 to 54
°
F (5 to 12
°
C).
Lower chamber
To view the SET temperature of either chamber at any time, press the
corresponding SET button. The SET temperature will show in the LED display
for about 5 seconds, then the current internal temperature for that chamber will
reappear.
corresponding SET button. The SET temperature will show in the LED display
for about 5 seconds, then the current internal temperature for that chamber will
reappear.
: Temperature setting can be adjusted from 54 to 72
°
F (12 to
22
°
C).
In the event of a power interruption, all previous temperature settings are
automatically saved and each chamber will keep the previous temperature setting.
(The temperature preset at the factory is 41°F (5°C) for the upper chamber and
54°F (12°C) for the lower chamber.)
automatically saved and each chamber will keep the previous temperature setting.
(The temperature preset at the factory is 41°F (5°C) for the upper chamber and
54°F (12°C) for the lower chamber.)
This unit has the option to display temperatures in either Fahrenheit or Celsius. To
change the setting, press the °C/°F button. A green light will indicate whether
Fahrenheit or Celsius temperatures are being displayed.
change the setting, press the °C/°F button. A green light will indicate whether
Fahrenheit or Celsius temperatures are being displayed.
NOTES: If the unit is unplugged or turned off, or if there is a power failure, you
must wait 3 to 5 minutes before restarting the unit. If you attempt to restart
before this time delay, the wine cooler will not start.
before this time delay, the wine cooler will not start.
When you use the wine cooler for the first time, or restart the wine cooler after it
has been shut off for a long time, there could be a few degrees variation
between the temperature you select and the one indicated on the LED readout.
This is normal and is due to the length of the inactivation time. Once the wine
cooler has been running for a few hours, it should operate normally.
has been shut off for a long time, there could be a few degrees variation
between the temperature you select and the one indicated on the LED readout.
This is normal and is due to the length of the inactivation time. Once the wine
cooler has been running for a few hours, it should operate normally.
Interior Light
You can turn the interior light on or off by pushing the button marked LIGHT. For
best storage of wine, keep the light off except when viewing.
NOTE: The light goes off automatically after 10 minutes.
You can turn the interior light on or off by pushing the button marked LIGHT. For
best storage of wine, keep the light off except when viewing.
NOTE: The light goes off automatically after 10 minutes.
Door Lock
This unit can be secured with a lock and key. The keys are located inside the
plastic bag that contains the User’s Manual. Insert the key into the lock and turn it
clockwise to lock the door, making sure the metal pin is engaged completely. To
unlock the door, do the reverse. Remove the key and put it in a secure location.
plastic bag that contains the User’s Manual. Insert the key into the lock and turn it
clockwise to lock the door, making sure the metal pin is engaged completely. To
unlock the door, do the reverse. Remove the key and put it in a secure location.
Defrosting
The wine cooler defrosts automatically during its operating cycle. The water
resulting from the defrosting is collected in a drip tray near the compressor at the
back where it is automatically evaporated. During the defrosting operation, the
displayed temperature may be higher than the set temperature.
resulting from the defrosting is collected in a drip tray near the compressor at the
back where it is automatically evaporated. During the defrosting operation, the
displayed temperature may be higher than the set temperature.