Fisher & Paykel OR36SDBMX1 Installationsanweisungen

Seite von 56
THIS RANGE IS FOR RESIDENTIAL USE ONLY
FOR INSTALLER ONLY
590979A
   1
104904-ß1  06.15
GAS RANGE
for residential use only
Models:
 
OR36SDBMX
USERS OPERATING INSTRUCTIONS
IMPORTANT - PLEASE READ AND FOLLOW
• 
Before beginning, please read these instructions completely and carefully.
• 
Do not remove permanently affi xed labels, warnings, or plates from the product. This may 
void the warranty.
• 
Please observe all local and national codes and ordinances.
• 
Please ensure that this product is properly grounded.
• 
The electrical plug should always be accessible.
• 
The installer should leave these instructions with the consumer who should retain 
for local inspector’s use and for future reference.
Installation must conform with local codes or in the absence of codes, the National Fuel Gas 
Code ANSI Z223.1/NFPA 54 - Iatest edition. Electrical installation must be in accordance with 
the National Electrical Code, ANSI/NFPA70 - latest edition and/or local codes.
IN CANADA: Installation must be in accordance with the current CAN/CGA-B149.1 National 
Gas Installation Code or CAN/CGA-B149.2, Propane Installation Code and/or local codes.
Electrical installation must be in accordance with the current CSA C22.1 Canadian Electrical 
Codes Part 1 and/or local codes.
INSTALLATION IN MANUFACTURED (MOBILE) HOME: The installation must conform with 
the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 [formerly 
the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD (Part 280)] 
or, when such standard is not applicable, the Standard for Manufactured Home Installations, 
ANSI/NCSBCS A225.1, or with local codes where applicable.
INSTALLATION IN RECREATIONAL PARK TRAILERS: The installation must conform with 
state or other codes or, in the absence of such codes, with the Standard for Recreational Park 
Trailers, ANSI A119.5.
Installation of any gas-fi red equipment should be made by a licensed plumber. A manual shut-
off valve must be installed in an accessible location in the gas line external to the appliance 
for the purpose of turning on or shutting off gas to the appliance (In Massachusetts such shu-
toff devices should be approved by the Board of State Examiners of Plumbers & Gas Fitters).
If an external electrical source is utilized, the appliance, when installed, must be electrically 
grounded in accordance with local codes or, in the absence of local codes, with the national 
Electrical Code, ANSI/NFPA 70.
Some models are supplied with a protective fi lm on steel and aluminium 
parts. This fi lm must be removed before installing/using the appliance.
R